Newvbie hard drive controller question
Zer0bit_at_yahoo.com
Date: 05/23/04
- Previous message: Curt Howland: "Quick mencoder question"
- Next in thread: Bob Proulx: "Re: Newvbie hard drive controller question"
- Reply: Bob Proulx: "Re: Newvbie hard drive controller question"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Sat, 22 May 2004 15:10:05 -0700 (PDT) To: debian-user@lists.debian.org
I'm new to Debian and I've loaded 2.2.20-compact on a Compaq Proliant DL380 that
is in a remote location. The DL380 has a SmartArray SCSI RAID controller which
is working well, it also has two IDE controllers, the on-board Compaq
controller, and a PCI SIIG "raid" controller. The on-board controller works
fine, but I am not able to access the PCI card based controller which has two WD
120GB drives in a software RAID that are used for backup.
The PCI controller card was detected at install, but it seems that the drivers
aren't loaded in the installed kernel as I don't see any info in dmesg and can't
access the devices attached to the controller.
Unfortunatly I don't have much info on the PCI card. I'm 90% sure it's a SIIG,
but no info other than that. How can I go about detecting the controller and
getting the right driver loaded so I can mount the disk?
I'm hundreds of miles from the server so botching up the kernel would be bad...
Any info is appreciated!
__________________________________
Do you Yahoo!?
Yahoo! Domains – Claim yours for only $14.70/year
http://smallbusiness.promotions.yahoo.com/offer
-- To UNSUBSCRIBE, email to debian-user-REQUEST@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
- Previous message: Curt Howland: "Quick mencoder question"
- Next in thread: Bob Proulx: "Re: Newvbie hard drive controller question"
- Reply: Bob Proulx: "Re: Newvbie hard drive controller question"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
