RTL8139 Full Duplex with a non-modular kernel
From: Gerard Sharpe (gerards_at_hunterlink.net.au)
Date: 06/28/04
- Previous message: Antonio Lobato: "Re: Attach filter"
- Next in thread: Micha Feigin: "Re: RTL8139 Full Duplex with a non-modular kernel"
- Reply: Micha Feigin: "Re: RTL8139 Full Duplex with a non-modular kernel"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
To: <debian-user@lists.debian.org> Date: Tue, 29 Jun 2004 00:36:01 +1000
Hi, I am after some advice for setting a RTL8139 NIC to 100MB full duplex on
a non-modular kernel.
I can do this with a modular kernel, but am not sure how to go about it on a
monolithic kernel. The mii-tool does not seem to support the rtl8139 driver
installed with the 2.4.26 kernel and reports incorrectly that the card is
already at 100baseT-FD. using rtl8139-diag shows the eeprom is set to
10baseT-HD but for the life of me cannot work out how to set it to
100baseT-FS (have tried rtl8139-diag -w -F 100baseT-FD without success).
Any advice will be much appreciated.
Thx
Gerard
-- To UNSUBSCRIBE, email to debian-user-REQUEST@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
- Previous message: Antonio Lobato: "Re: Attach filter"
- Next in thread: Micha Feigin: "Re: RTL8139 Full Duplex with a non-modular kernel"
- Reply: Micha Feigin: "Re: RTL8139 Full Duplex with a non-modular kernel"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|