Re: mii-tool eth0 wierdness
From: Simon Buchanan (nmc_at_orcon.net.nz)
Date: 09/30/04
- Previous message: Greg Pierce: "Re: Re: Volume control broken after Gnome 2.6 Upgrade"
- Maybe in reply to: Simon Buchanan: "mii-tool eth0 wierdness"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Thu, 30 Sep 2004 10:28:04 +1200 To: debian-user@lists.debian.org
Raghavendra Bhat wrote:
>>>mii-tool -v eth0
>>>eth0: 10 Mbit, half duplex, no link
>>>product info: vendor 00:00:00, model 0 rev 0
>>>basic mode: 10 Mbit, half duplex
>>>basic status: no link
>>>capabilities:
>>>advertising:
>>
>>>and its connected to a 100Mbit hub
>
>
> Try 'mii-tool -v --force-media=100baseTx-FD eth0' and then check whether
> the link has been negotiated. I think that the link was not established
> due to capability mismatch.
I have tried this, but nothing happens... Here is what i did:
server:~# mii-tool -v --force=100baseTx-FD eth0
server:~# mii-tool -v
eth0: 10 Mbit, half duplex, no link
product info: vendor 00:00:00, model 0 rev 0
basic mode: 10 Mbit, half duplex
basic status: no link
capabilities:
advertising:
Very strange. I have tried a different port on the hub with no change to
the above. BTW: All other servers are at 100base-Tx. Here is some more
output:
server:~# mii-diag -a
Using the default interface 'eth0'.
Basic registers of MII PHY #32: 0000 0000 0000 0000 0000 0000 0000 0000.
Basic mode control register 0x0000: Auto-negotiation disabled, with
Speed fixed at 10 mbps, half-duplex.
Basic mode status register 0x0000 ... 0000.
Link status: not established.
Link partner information information is not exchanged when in fixed
speed mode.
End of basic transceiver informaion.
server:~# ethtool eth0
Settings for eth0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Supports auto-negotiation: Yes
Speed: 10Mb/s
Duplex: Half
Port: MII
PHYAD: 0
Transceiver: internal
Auto-negotiation: off
Supports Wake-on: pumbg
Wake-on: d
The Ethernet Card is as follows:
server:~# lspci
00:0c.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139
(rev 10)
Any further help is greatfull.
-- To UNSUBSCRIBE, email to debian-user-REQUEST@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
- Previous message: Greg Pierce: "Re: Re: Volume control broken after Gnome 2.6 Upgrade"
- Maybe in reply to: Simon Buchanan: "mii-tool eth0 wierdness"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
|
