Re: Kernel 2.6.10 boots panic

From: Adam Aube (aaube01_at_baker.edu)
Date: 01/29/05

  • Next message: Adam Aube: "Re: security" 
    To: debian-user@lists.debian.org
Date: Fri, 28 Jan 2005 21:42:25 -0500

    CN wrote:

    >> Because kernel 2.6 includes Promise driver (under SCSI sub-menu), I
    >> compiled kernel 2.6.10 from source and did lilo. However, when booting
    >> 2.6.10, I get the following panic:

    >> VFS: Cannot open root device "301" or unknown-block(3,1)
    >> Please append a correct "root=" boot option
    >> VFS: Unable to mount root fs on unknown-block(3,1)

    > Today I inserted this same IDE disk back to the no-brand box and the
    > same problem happens when booting v2.6.10. Hence I think there are
    > issues associated with kernel 2.6.10. Any idea?

    Most likely support for your IDE chipset was not compiled into your kernel.

    Adam 

    -- 
To UNSUBSCRIBE, email to debian-user-REQUEST@lists.debian.org 
with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
  • Next message: Adam Aube: "Re: security"

    Relevant Pages

    • Re: Kernel 2.6.17
      ... I'm using LiLo, so ... but is there a way to install the 2.6.17 ... you can install the 2.6.17 kernel by using dpkg: ... I must say I have some concerns about even booting the 2.6.18 kernel, ...
      (Debian-User)
    • [SLE] Kernel 2.6 - AX25 problems.
      ... Compiled new kernel 2.6.0 and so far so good. ... Did a test with compiled kernel 2.6.0 (after change some things on lilo) ... and still have AX25 problems, my uscc-card does not work yet. ...
      (SuSE)
    • Re: 2.6.25 slow boot/reboot
      ... Do you use LILO or GRUB for booting? ... GRUB loads the 2.6.25 kernel at normal speed. ... I use LILO, but read your answer and tested GRUB, and you are right, GRUB starts the boot process much faster than LILO, but I was talking about the time it takes once the kernel is booting already. ...
      (Linux-Kernel)
    • Re: LILO fatal error after going from 2.6.22 to 2.6.24.2
      ... I have just upgraded from 2.6.22 to 2.6.24.2 and after booting into the ... new kernel the default boot kernel. ... default this is the same lilo config as 2.6.22 was able to write fine. ... You have at least one file on a device mapper device (possibly an LVM module), ...
      (Linux-Kernel)
    • Re: How to get Sound to work - Need step by step instructions
      ... > forget to configure lilo to use the initrd needed to boot that kernel. ... > After booting with the new kernel, ... I tried 'ditching' that kernel by upgrading to Sarge. ...
      (Debian-User)