Re: sata drives
From: p_s (duke_p_at_saunalahti.fi)
Date: 01/30/05
- Previous message: Hannes Mayer: "Sarge: plenty of free RAM, but uses swap"
- In reply to: Clive Menzies: "Re: sata drives"
- Next in thread: p_s: "Re: sata drives"
- Reply: p_s: "Re: sata drives"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Sun, 30 Jan 2005 15:41:59 +0200 To: debian-user@lists.debian.org
Clive Menzies wrote:
> On (30/01/05 08:31), p_s wrote:
>
>>Clive Menzies wrote:
>>
>>>On (29/01/05 23:23), duke_p@saunalahti.fi wrote:
>>>
>>>
>>>>I am trying t o install debian testing to my new laptop, which has sata
>>>>haddrives, and I miserably fail when partitioning.. Installer notifies
>>>>that 'no partionable media found'
>>>>
>>>>I tried to boot with:
>>>>linux26
>>>
>>>Try expert26 IIRC .... It worked for me ;)
>>>
>>>Regards
>>>
>>
>>Didn't get far, the list of modules the installer offers here too is all
>>for IDE chipsets.
>>
>>I googled around and some suggest that turn off the sata from bios, but
>>sadly that's not possible on my bios.
>
> You are using the sarge d-i rc2 installer?
>
>>From memor: I setup a couple of servers with software RAID on SATA
> drives in Decmber. I booted into the installer with "expert26" and that
> gave all sorts of options of packages to run during the install and
> support for SATA and RAID were in there.
Yep, I have tried both, sarge netinstall (rc2) and the full images, both
ended up similarily, no paartionable media.
I just tried it again with expert26, it suggests a heap load of modules
it assumes necessary...(sorry the possible typos, couldn't copy/paste
these..)
yenta_sockets, usb-storage. floppy, via82cxxx, trm290, triflex,
slc90e66, sis5513, siimage, serverworks, sc1200, rz1000, piix,
pdc202xx_old, opti621, ns87415, hpt34xx, generic, cy83c693, cs5530,
cs5520, cmd64x, atiixp, and74xx, alim15x3, alim15x3, aec62xx,
pdc202xx_new, ide-generic, ide-disk, ide-cd, isofs)
I allowed all, didn't know what parameters to pass to them though.
under Knoppix lspci output is revealed that the SATA Controller is:
0000:00:1f.2 IDE interface: Intel Corp. 82801FBM (ICH6M) SATA Controller
(rev 04)
Any modules to load via the shell with modprobe possibly ?
TIA,
PETE
-- To UNSUBSCRIBE, email to debian-user-REQUEST@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
- Previous message: Hannes Mayer: "Sarge: plenty of free RAM, but uses swap"
- In reply to: Clive Menzies: "Re: sata drives"
- Next in thread: p_s: "Re: sata drives"
- Reply: p_s: "Re: sata drives"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
|
