Re: bcm5700 driver installation problem
From: Colin (cwvca_spamr_at_hotmail.com)
Date: 05/08/05
- Previous message: s. keeling: "Re: bash command substitution problem"
- In reply to: Amira Youssef: "bcm5700 driver installation problem"
- Next in thread: Wackojacko: "Re: bcm5700 driver installation problem"
- Reply: Wackojacko: "Re: bcm5700 driver installation problem"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Sun, 08 May 2005 13:48:55 -0400 To: debian-user@lists.debian.org
Amira Youssef wrote:
> Hello,
>
> After I've managed to compile the gigabit N/W card driver bcm5700, It
> gave error while trying to install it:
>
> output of insmod bcm5700.o:(using Woody 3.0 r 2, kernel 2.4.18-1-686-smp)
> ------------------------------------------
> bcm7500.o: init_modules:no such device
> Hint: insmod errors can be caused any incorrect module parameters,
> including invalid IO or IRQ parameters
Isn't the kernel's "tg3" module suppose to use this NIC?
-- To UNSUBSCRIBE, email to debian-user-REQUEST@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
- Previous message: s. keeling: "Re: bash command substitution problem"
- In reply to: Amira Youssef: "bcm5700 driver installation problem"
- Next in thread: Wackojacko: "Re: bcm5700 driver installation problem"
- Reply: Wackojacko: "Re: bcm5700 driver installation problem"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|