Re: cannot mount cdrom!
From: steef (steefvanduin_at_zonnet.nl)
Date: 05/21/05
- Previous message: steef: "Re: Burning Cd's"
- In reply to: Aaron Maxwell: "cannot mount cdrom!"
- Next in thread: Aaron Maxwell: "Re: cannot mount cdrom!"
- Reply: Aaron Maxwell: "Re: cannot mount cdrom!"
- Reply: steef: "Re: cannot mount cdrom!"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Sat, 21 May 2005 19:53:09 +0200 To: debian@murphy.debian.org:gebruikerslijst <debian-user@lists.debian.org>
Aaron Maxwell wrote:
>Hi, I recently upgraded most of the hardware on my system, but pulled
>out the cdrom and installed it in the new box. Now I am not able to
>mount it successfully. This is a normal ATAPI IDE cdrom drive, and I'm
>running testing. The kernel is 2.6.10 and of course has the atapi
>driver compiled in.
>
>/dev/hdc is the cdrom device. This is what happens when I try to mount
>it:
>---
>jashenki:~# mount -t iso9660 -r /dev/hdc /mnt/cdrom
>mount: wrong fs type, bad option, bad superblock on /dev/hdc,
> missing codepage or other error
> In some cases useful info is found in syslog - try
> dmesg | tail or so
>---
>The output of dmesg seems to indicate that everything is fine, up until
>I try to mount it. Here is the related output:
>---
>VP_IDE: VIA vt8237 (rev 00) IDE UDMA133 controller on pci0000:00:0f.1
> ide0: BM-DMA at 0xfc00-0xfc07, BIOS settings: hda:DMA, hdb:DMA
> ide1: BM-DMA at 0xfc08-0xfc0f, BIOS settings: hdc:DMA, hdd:pio
>...
>Probing IDE interface ide1...
>hdc: E-IDE CD-ROM CR-850E, ATAPI CD/DVD-ROM drive
>ide1 at 0x170-0x177,0x376 on irq 15
>...
>hdc: ATAPI 50X CD-ROM drive, 128kB Cache, UDMA(33)
>Uniform CD-ROM driver Revision: 3.20
>---
>
>And then when I attempt the mount this message shows up in dmesg's tail:
>
>---
>hdc: command error: status=0x51 { DriveReady SeekComplete Error }
>hdc: command error: error=0x54
>ide: failed opcode was 100
>end_request: I/O error, dev hdc, sector 64
>isofs_fill_super: bread failed, dev=hdc, iso_blknum=16, block=16
>---
>
>The drive's jumper is set to "cable select". I originally had it set to
>master, and changed it to see if it would fix the problem.
>
>Any ideas? Thanks in advance.
>
>
>
peace to you too.
what happens if you leave <-r> out?
steef
-- To UNSUBSCRIBE, email to debian-user-REQUEST@lists.debian.org with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
- Previous message: steef: "Re: Burning Cd's"
- In reply to: Aaron Maxwell: "cannot mount cdrom!"
- Next in thread: Aaron Maxwell: "Re: cannot mount cdrom!"
- Reply: Aaron Maxwell: "Re: cannot mount cdrom!"
- Reply: steef: "Re: cannot mount cdrom!"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
