Re: Installing D-Link DGE-530T Gigabit NIC on an Woody 3.0r5 after Install.

From: Siju George (sgeorge.ml_at_gmail.com)
Date: 06/08/05

  • Next message: M. Maas: "Re: Cupsaddsmb only running "setdriver"" 
    Date: Wed, 8 Jun 2005 13:16:10 +0530
To: debian-user@lists.debian.org

    On 6/8/05, Colin Ingram <synergizedmusic@gmail.com> wrote:
    > Siju George wrote:
    >
    > >Hi al,
    > >
    > >I have been working on a debian woody 3.0r5 for which I have to
    > >install a D-Link DGE-530T Gigabit NIC o it now.
    > >
    > >Running
    > >
    > >#modconf
    > >
    > >and looking under
    > >
    > >kernel/drivers/net Drivers for network interface cards
    > >
    > >I find
    > >
    > > dl2k - D-Link 2000-based Gigabit Ethernet support
    > >
    > >Could someone please tell me if it is the right module I should
    > >Install to get the Gigabit NIC working or should I use the driver on
    > >the CD.
    > >
    > >
    > >
    > D-link DGE-530T uses the sk98lin driver. I was not able to get it to
    > work with the module included with the 2.4.x kernels and Woody, however
    > the module in kernel 2.6.8 (sarge) works fine. When I was using woody I
    > installed the driver from SysKonnect.
    >
    > http://www.syskonnect.com/syskonnect/support/driver/
    >
    > I would try the one that comes with the kernel first though since I
    > might have had some other problem.
    >
    >

    Thanks a lot Colin for your feed back.

    good luck

    kind regards

    Siju

  • Next message: M. Maas: "Re: Cupsaddsmb only running "setdriver""