Question about PCI IDs and Drivers

I have a new Network Card, and I found the VENDOR ID and the DEVICE ID.
I found it in "lspci -nv" and later looking for the given number in
/var/libs/pciutils/pci.ids, but now, how do I know which driver to
use? And if Debian has it compiled?

The card is (listed with pci.ids) :

1904 Hangzhou Silan Microelectronics Co., Ltd.
8139 RTL8139D [Realtek] PCI 10/100BaseTX ethernet adaptor

Now, the output of lspci -v :

0000:00:0b.0 Ethernet controller: Hangzhou Silan Microelectronics Co.,
Ltd. RTL8139D [Realtek] PCI 10/100BaseTX ethernet adaptor (rev 01)
Flags: bus master, medium devsel, latency 64, IRQ 11
Memory at cfff7f00 (32-bit, non-prefetchable) [size=256]
I/O ports at d000 [size=256]
Expansion ROM at cffa0000 [disabled] [size=128K]
Capabilities: [50] Power Management version 2
Capabilities: [60] Vital Product Data


I think is the Driver 8139too, but when I modprobe it, my Network
Cards still doesnt work.

If I do "ifconfig eth1 10.0.0.221 255.255.255.0 up" it says No Such Device.

Thanks!!


--
To UNSUBSCRIBE, email to debian-user-REQUEST@xxxxxxxxxxxxxxxx with a subject of "unsubscribe". Trouble? Contact listmaster@xxxxxxxxxxxxxxxx

Relevant Pages

  • Re: Question about PCI IDs and Drivers
    ... The card is: ... the output of lspci -v: ... Is "common sense" really valid? ... To UNSUBSCRIBE, email to debian-user-REQUEST@xxxxxxxxxxxxxxxx ...
    (Debian-User)
  • Re: VIA OnBoard NIC problems
    ... I'm running 5.2 right now with a VIA EPIA 800 setup. ... card, vr0, and it seems to work so far, then again I don't have ... >> To unsubscribe, send any mail to ...
    (freebsd-questions)
  • Re: Question about PCI IDs and Drivers
    ... The card is: ... the output of lspci -v: ... There is also 8139cp which according to the comments in the source file ... To UNSUBSCRIBE, email to debian-user-REQUEST@xxxxxxxxxxxxxxxx ...
    (Debian-User)
  • Re: X-Config...
    ... It should identify the card and propose to use the "nv" driver. ... goes wrong you can use lspci to find out the bus address. ... To UNSUBSCRIBE, email to debian-user-REQUEST@xxxxxxxxxxxxxxxx ...
    (Debian-User)
  • RE: DFE-670TXD
    ... > using the ED* module on it, and for some reason I can only get out to ... The card is a PCMCIA 10/100 card. ... Have you also tested the cable with a different network card too? ... To unsubscribe, ...
    (freebsd-newbies)