Re: Can't ping

On fre, 2006-08-04 at 14:38 +0200, Helge Stenström (KI/EAB) wrote:
I can't ping either. I have Debian Sid, and made a system upgrade in late July. Is the cause the same?

pinging other machines on the same subnet works.

The route command takes very long time (40 seconds), but gives the expected result. (disclaimer: I don't understand this stuff, but I can compare with machines that work)
The route -n command is quick, and gives the expected result.

From /etc/resolv.conf:
search rnd.ki.sw.ericsson.se
nameserver 147.214.214.11
nameserver 147.214.214.111

I cannot ping the nameservers by IP. I can from other machines, of from the same machine running Knoppix.

The ifconfig eth0 command gives the expected result (same disclaimer)

Result of "route -n | grep eth"
147.214.195.0 0.0.0.0 255-255-255-0 U 0 0 0 eth0
0.0.0.0 147.214.195.1 0.0.0.0 UG 0 0 0 eth0

I don't understand if this is a problem with a configuration file or with a program that got downloaded when I upgraded the system. I hope it's a configuration thing, because then it's easier to repair.

Regards,
Helge Stenström



Hi Helge and all.

I could only see output regarding 'eth0', but it seems that more
interfaces are involved. I had a simiar problem at my place, and the
only advice I can give is that you guys need to check your entire
routing structure.
It is impossible for us (i.e. me) to give an answer based on on half the
truth.
Make sure that you haven't made the misstake to route through several
interfaces that don't have the conectivity required.

/nicolaus Kedegren




--
To UNSUBSCRIBE, email to debian-user-REQUEST@xxxxxxxxxxxxxxxx
with a subject of "unsubscribe". Trouble? Contact listmaster@xxxxxxxxxxxxxxxx

Relevant Pages

  • Re: Cant ping
    ... pinging other machines on the same subnet works. ... The route command takes very long time, ... The ifconfig eth0 command gives the expected result (same disclaimer) ...
    (Debian-User)
  • Summary: Changes to mv in upgrade from 5.1 to 5.1b?
    ... Tim was able to duplicate this bug on his own machines testing between 5.1 ... As far as whether this was an intentional change on HP's part or a bug, ... Some of our scripts are now failing with the "mv" command with an error I ...
    (Tru64-UNIX-Managers)
  • Re: Please Gurus here solve my simple nw problem
    ... >> the router by virtue of being directly connected networks. ... >> The hosts on USERLAN have to have 192.168.0.1 as their default gw. ... If this is the case, then most of the machines in USERLAN, including ... route intenet traffic over its DSL. ...
    (comp.os.linux.networking)
  • Re: Good wireless signal - but browser cannot find it?
    ... Packet Scheduler Miniport ... Type this command, then reboot: ... please post a copy of the computer's route ... fraction of a second and then disappears. ...
    (microsoft.public.windowsxp.network_web)
  • Re: send command
    ... xhost table in order to use the tcl "send" command. ... your display to any app you have rights to start. ... machines you need to run X apps on. ...
    (comp.lang.tcl)