Re: smartctl trackrecord



On Wed, 31 Jan 2007, Hugo Vanwoerkom wrote:
Anyone using 'smartctl -t long ... ' actually ever encountered errors
*before* they showed up in the logs as seek errors?

Yes.

If so what did you do?

Pulled out the disk from the RAID array, zeroed it, run a new extended
offline test on it, which proved that the drive had remapped the bad sector
away and no others showed up, and added it back to the RAID array.

--
"One disk to rule them all, One disk to find them. One disk to bring
them all and in the darkness grind them. In the Land of Redmond
where the shadows lie." -- The Silicon Valley Tarot
Henrique Holschuh


--
To UNSUBSCRIBE, email to debian-user-REQUEST@xxxxxxxxxxxxxxxx
with a subject of "unsubscribe". Trouble? Contact listmaster@xxxxxxxxxxxxxxxx



Relevant Pages

  • how to do/repair a raid1 missing disk install (was: Re: lilo + raid = disaster (again))
    ... Lilo promptly corrupted some of your data. ... Get a boot disk that supports RAID1, your SATA drives, and whatever ... Repair whatever is the first thing in your RAID array. ...
    (Debian-User)
  • Re: Debian Raid Crash Repair
    ... what you do depends on how you want the new disk to be used... ... Boot single user. ... Create a new RAID array in degraded mode using mdadm. ... don't forget the swap partition!). ...
    (Debian-User)
  • Re: repartitioning software raid1 -- remotely?
    ... > you start playing with partitions, you can also enable lvm support.. ... > where hdc is the LVM+Raid disk and hda is the disk with ugly partitioning ... >> so how do we split the raid up without borking the remote ... > member partitions as if they were not part of the raid array. ...
    (Debian-User)
  • Re: IBM SSA 160 question
    ... Concurrent disk replacement in an SSA RAID Array. ... Select Change Member Disks in an SSA RAID Array. ...
    (AIX-L)
  • Re: Disk Configuration - Best Practices
    ... put the logs on a separate physical disk. ... have to be in a RAID array. ... > the best configuration for Exchange. ...
    (microsoft.public.exchange.setup)