Re: cups and samba stop working after upgrade to etch
- From: Florian Kulzer <florian.kulzer+debian@xxxxxxx>
- Date: Sat, 21 Apr 2007 21:50:43 +0200
On Fri, Apr 20, 2007 at 11:25:26 -0400, Bill Shofner wrote:
After upgrading my sarge box to etch, I cannot print and samba no longer
works. When I re-boot I get the following message from root:
The Samba 'panic action' script, /usr/share/samba/panic-action,
was called for PID 2540 (/usr/sbin/smbd).
This means there was a problem with the program, such as a segfault.
Below is a backtrace for this process generated with gdb, which shows
the state of the program at the time the error occurred. The Samba log
files may contain additional information about the problem.
[...]
I cannot print from the printer attached to this system either and when I
try to go to http://localhost:631 I get:
An error occurred while loading http://localhost:631:
Could not connect to host localhost (port 631).
[...]
At this point I do not know if the underlying problem is in cups or samba
or something else. Any pointers or suggestions will be greatfully received.
Just to get this out of the way first: Are you sure that your upgrade is
complete? Did you use the procedure outlined in the release notes?
--
Regards, | http://users.icfo.es/Florian.Kulzer
Florian |
--
To UNSUBSCRIBE, email to debian-user-REQUEST@xxxxxxxxxxxxxxxx
with a subject of "unsubscribe". Trouble? Contact listmaster@xxxxxxxxxxxxxxxx
- Follow-Ups:
- Re: cups and samba stop working after upgrade to etch
- From: Bill Shofner
- Re: cups and samba stop working after upgrade to etch
- References:
- cups and samba stop working after upgrade to etch
- From: Bill Shofner
- cups and samba stop working after upgrade to etch
- Prev by Date: Re: Updated Sid today, xorg cannot find "nvidia" driver
- Next by Date: Re: custom kernel on etch?
- Previous by thread: cups and samba stop working after upgrade to etch
- Next by thread: Re: cups and samba stop working after upgrade to etch
- Index(es):
Relevant Pages
|
|
