Re: Touchpad speed
- From: Jörg-Volker Peetz <peetz@xxxxxxxxxxxxxxxxxx>
- Date: Mon, 21 May 2007 14:18:23 +0200
Matthias Brennwald wrote:
Dear allDo you have an Alps touchpad? Take a look at the output of
moving the cursor with the touchpad of my PowerBook G4 is very slow in
Debian Etch. I played around with the settings in xorg.conf, and that
helped a bit, but it's still rather slow. I mainly played with
'AccelFactor' (I used values 0.001, 0.01, 0.1, 1, and 10) and
'HorizScrollDelta' and 'VertScrollDelta' (I used values 0, 1, 10 and
100). My current settings are:
Section "InputDevice"
Identifier "Synaptics Touchpad"
Driver "synaptics"
Option "SendCoreEvents" "true"
Option "Device" "/dev/psaux"
Option "Protocol" "auto-dev"
Option "HorizScrollDelta" "100"
Option "VertScrollDelta" "100"
Option "AccelFactor" "0.01"
EndSection
Any ideas or hints on how to speed up my cursor from the touchpad?
Matthias
cat /proc/bus/input/devices
The Alps touchpad needs a different configuration, see
/usr/share/doc/xserver-xorg-input-synaptics/README.alps
--
Regards,
Jörg-Volker.
--
To UNSUBSCRIBE, email to debian-user-REQUEST@xxxxxxxxxxxxxxxx
with a subject of "unsubscribe". Trouble? Contact listmaster@xxxxxxxxxxxxxxxx
- References:
- Touchpad speed
- From: Matthias Brennwald
- Touchpad speed
- Prev by Date: Re: vesa display codes (Etch Xorg memory leak?)
- Next by Date: Re: mounting LVM partitions fails after etch upgrade
- Previous by thread: Re: Touchpad speed
- Next by thread: matlab r2007a installation problems
- Index(es):
Relevant Pages
|