i am using etch, kernel 2.6.18-5-486. it worked fine till xine (compiled
from their site) without any warning started crashing the xserver, and
mplayer (compiled from 'their' site too) refused to start up with the
message 'segmentation fault'. i repeated this several times for both,
xine and mplayer, with the same results. in my opinion i did nothing
peculiar to have caused this myself.
i compiled </home/steef/NVIDIA-Linux-x86-1.0-9755-pkg1.run> in to my
kernel ages ago. all worked fine for months.
i guess i can live with this (got another machine with a etch and lenny
distro) but i am very curious what can be the cause of this and what i
can do to repair thids should it somehow happen agaian.
in advance thanks for your help
regards,
steef
--
To UNSUBSCRIBE, email to debian-user-REQUEST@xxxxxxxxxxxxxxxx
with a subject of "unsubscribe". Trouble? Contact listmaster@xxxxxxxxxxxxxxxx
segmentation_fault ... i am using etch, kernel 2.6.18-5-486. ... it worked fine till xine without any warning started crashing the xserver and mplayer refused to start up with the message 'segmentation fault'. ... i guess i can live with this (got another machine with a etch and lenny distro) but i am very curious what can be the cause of this and what i can do to repair thids should it somehow happen agaian. ... (Debian-User)
Re: cdrecord wihout SUID ...etch too here:) ... device to write is dependent on the kernel you use, ... (apparently because of an inability as a user to gain access to certain ... To UNSUBSCRIBE, email to debian-user-REQUEST@xxxxxxxxxxxxxxxx ... (Debian-User)
Etch is REALLY fast! :-) ... I have been sticking with Sarge, and I had been using a backports kernel that I custom compiled back in February, but when I bought a new video card recently I found that I had to compile a new kernel module to get 3D working properly. ... Since Etch is nearly ready to be released, I decided that my best bet was to keep the new kernel and replace everything else! ... To UNSUBSCRIBE, email to debian-user-REQUEST@xxxxxxxxxxxxxxxx with a subject of "unsubscribe". ... (Debian-User)
Re: Error message about cdrom tray open during boot ... Have you tried reinstalling the kernel?... is not in Etch.... If you're running lenny or sid with a 2.6.18-4 ... To UNSUBSCRIBE, email to debian-user-REQUEST@xxxxxxxxxxxxxxxx ... (Debian-User)
Re: libc6 with support for old kernels ... some updates a bit back, now gives me a "kernel to old" message. ... I did a bootstrap of etch, copied that on the old machines, and it works! ... To UNSUBSCRIBE, email to debian-user-REQUEST@xxxxxxxxxxxxxxxx ... (Debian-User)
