Re: mount USB drive at boot: fsck failure

Ron,

Interesting: when the USB drive is on, the box stalls during POST. It is apparently some kind of deadlock, because when I power down the drive POST completes immediately.

Bogart

On Dec 3, 2007, at 5:50 PM, Ron Johnson wrote:

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

On 12/03/07 16:39, Bogart Salzberg wrote:
Dear Debian Users,

I partitioned and installed an ext3 filesystem on an external 250 GB
Western Digital USB 2.0 drive. It mounts OK manually and I can
read/write it. I added this line to /etc/fstab in order to mount the
drive at boot time:

/dev/sdc1 /archive ext3 defaults 0 3

Upon reboot, I got an error at the console re: fsck not finding a valid
filesystem. But when I exit the maintenance shell and continue booting,
the drive mounts as specified and "fsck /dev/sdc1" reports clean.

Are the USB drivers not loading in time? I tried changing the "pass"
value in column 6 of /etc/fstab to 0. This had the desired effect of
skipping the fsck checks, but the drive did not automount either.

Has anyone else out there encountered this problem with mounting USB
drives at boot?

Stock Debian binary kernel or home-rolled?

Also, does anyone have any hints for recovering all of the startup
console messages after boot? I get a lot out of "dmesg" and
"/var/log/kern.log", but some messages are missing. For example, the
fsck messages. Are they being wiped out by messages from higher/other
run levels?

Also, the box stalled during POST after reboot, which I found
remarkable. Is it possible the USB drive has introduced an interrupt
problem?

Well that's Bad. Just one time?

Whoa, that's three issues in one message. ;-)


- --
Ron Johnson, Jr.
Jefferson LA USA

%SYSTEM-F-FISH, my hovercraft is full of eels
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.6 (GNU/Linux)

iD8DBQFHVIhMS9HxQb37XmcRAmfSAJ9ouYCNDEqHi3wgEIWM8oE7QZPotACffF6W
T0FxZERsyDP+dNpwJvyF/gs=
=tyAH
-----END PGP SIGNATURE-----


--
To UNSUBSCRIBE, email to debian-user-REQUEST@xxxxxxxxxxxxxxxx
with a subject of "unsubscribe". Trouble? Contact listmaster@xxxxxxxxxxxxxxxx



--
To UNSUBSCRIBE, email to debian-user-REQUEST@xxxxxxxxxxxxxxxx with a subject of "unsubscribe". Trouble? Contact listmaster@xxxxxxxxxxxxxxxx

Relevant Pages

  • Re: Largest External HDD I Can Use With a Dimension 8200?
    ... Got the problem with the external Maxtor OneTouch II drive resolved. ... I totally uninstalled and reinstalled the Maxtor software, and used a different USB port on the back of my D-8300. ... These problems with ALL THE USB DEVICES started about 6 months ago, and increased with frequency until recently they became intolerable. ... I use the two front USB ports to connect my PNY Flash Drives, and get errors when plugging in to forward connector, but not the back one. ...
    (alt.sys.pc-clone.dell)
  • Re: Installing Fedora without a CDROM: my HOWTO
    ... Here is my HOWTO on installing Linux from a USB drive, ... disk or USB key rather than a CDROM boot disk. ... Put auxillary files (special drivers, post setup install config, ... This way I can mount any number of hard drives in the ...
    (Fedora)
  • Re: Booting Vista from external drive violate MS EULA?
    ... of OS install to diff drives. ... Meaning this boots off usb vista, if there is another hard drive ...
    (microsoft.public.windows.vista.general)
  • Re: XP recognising an external USB drive
    ... It's running on Windows XP. ... for external hard drives that causes this problem (WinXP whilst operating ... to blame as the USB standard. ... itself won't recognise the drive on cold start, ...
    (microsoft.public.windowsxp.hardware)
  • Re: SATA HDD in external USB2 case no longer recognised after 1st reboot
    ... only to find that the SATA drive was no longer ... is it normal that I have 5 USB controllers in my device ... manager, ... both my external drives are Maxtor, but I know the "Maxtor 6 Y160P0 USB ...
    (microsoft.public.windowsxp.hardware)