Re: Ethernet card does not work after Mother Board Change
- From: Wayne Topa <linuxone@xxxxxxxxxxxxx>
- Date: Fri, 8 Feb 2008 22:25:09 -0500
Butch Kemper(kemper@xxxxxxxxx) is reported to have said:
I built a system using 4.0r2 net-install and have kernel 2.6.18-5-k7 installed.
The motherboard failed and the replacement board has a different type
ethernet card.
In the kern.log file, I can see the ethernet card is recognized and
called eth0 but:
The card is not connected to eth0 in ifconfig - there is no
eth0.
There is not an interrupt level in /proc/interrupts for the
ethernet card.
If I try an ifup eth0, I get an error about a non-existant
device.
I tried entering the driver name in /etc/modules but that does not help.
I need some assistance on how to proceed to get the system to properly
setup the ethernet card.
check the file
/etc/udev/rules.d/z25_persistent-net.rules
I suspect that there is now more then one eth0 entry.
ISTR that commenting out the old entry didn't work, so remove it and
reboot.
WT
--
There are two ways to write error-free programs; only the third one
works.
_______________________________________________________
--
To UNSUBSCRIBE, email to debian-user-REQUEST@xxxxxxxxxxxxxxxx
with a subject of "unsubscribe". Trouble? Contact listmaster@xxxxxxxxxxxxxxxx
- Follow-Ups:
- Re: Ethernet card does not work after Mother Board Change
- From: Butch Kemper
- Re: Ethernet card does not work after Mother Board Change
- References:
- Ethernet card does not work after Mother Board Change
- From: Butch Kemper
- Ethernet card does not work after Mother Board Change
- Prev by Date: Strange Claws Behavior
- Next by Date: Re: SUCCESS: Grub2 on Dell Optiplex GX270
- Previous by thread: Re: Ethernet card does not work after Mother Board Change
- Next by thread: Re: Ethernet card does not work after Mother Board Change
- Index(es):
Relevant Pages
|
|
