Re: wakeonlan
- From: Paul Csanyi <csanyipal@xxxxxxxxx>
- Date: Mon, 21 Apr 2008 19:35:21 +0200
Paul Csanyi <csanyipal@xxxxxxxxx> writes:
Paul Csanyi <csanyipal@xxxxxxxxx> writes:
Carl Fink <carlf@xxxxxxxxx> writes:
On Sun, Apr 20, 2008 at 05:10:40AM +0200, hh.eu@xxxxxx wrote:
Wake On LAN wakes a system from poweroff. There is no need to suspend or
hibernate.
I red in the motherboard manual:
"... It will allow the network to remotely power-on a Soft Power Off
(Soft-Off) PC. However, if your system is in the Suspend mode, you can
power-on the system only through an IRQ or DMA interrupt."
I red here too:
"Important: The 5VSB power source of your power supply must support
greater or equal 720 mA."
I have setup 'Enabled' in BIOS 'Power Management Setup' the 'Resume on PCI
Event' too, soo finally I can to wake on from gateway/router my server
box with wakeonlan.
I must to give too the proper Broadcast address to my LAN.
However I can't wake up the PC box debian server from the debian
gateway when I power off the debian server with shutdown command and
after that I plug off the power cable of the PC supply.
But when I power on the debian server with it's power button and right
after that I power it off with power button, then I can to wake up the
debian server from the debian gateway with wakeonlan command.
What cause this event?
I set up in debian server's Award BIOS the following:
* Integrated Peripherals / Onboard SuperIO Device / PWR Lost Resume
State: Turnk On
*Power Management Setup / Resume On PCI Event: Enabled
*Power Management Setup / Resume On LAN: Enabled
When the abowe mentioned PWR Lost Resume State was: Off, I can't too
to wake up debian server with wakeonlan.
I check that the power supply of the debian server has +5VSB / 2A and
that is enough to use wake on lan.
Why can't I wake up the debian server from the debian gateway with
wakeonlan?
Any advices will be appreciated!
--
Regards, Paul Csanyi
http://www.freewebs.com/csanyi-pal/index.htm
--
To UNSUBSCRIBE, email to debian-user-REQUEST@xxxxxxxxxxxxxxxx
with a subject of "unsubscribe". Trouble? Contact listmaster@xxxxxxxxxxxxxxxx
- Follow-Ups:
- Re: wakeonlan
- From: NN_il_Confusionario
- Re: wakeonlan
- References:
- wakeonlan
- From: Paul Csanyi
- Re: wakeonlan
- From: Andrei Popescu
- Re: wakeonlan
- From: Paul Csanyi
- Re: wakeonlan
- From: hh . eu
- Re: wakeonlan
- From: Carl Fink
- Re: wakeonlan
- From: Paul Csanyi
- Re: wakeonlan
- From: Paul Csanyi
- wakeonlan
- Prev by Date: is it possible to have clamd go to 90% of cpu ???
- Next by Date: Re: Source code editor
- Previous by thread: Re: wakeonlan
- Next by thread: Re: wakeonlan
- Index(es):