Re: Installing a Broadcom 4312 rev 02 wifi card
- From: Celejar <celejar@xxxxxxxxx>
- Date: Sun, 1 Mar 2009 01:31:01 -0500
On Fri, 27 Feb 2009 17:14:55 -0800
consultores1 <consultores1@xxxxxxxxx> wrote:
El vie, 27-02-2009 a las 16:22 -0500, Celejar escribió:
On Fri, 27 Feb 2009 15:39:55 +0100
Korrignu <korrignu@xxxxxxxxx> wrote:
...
06:00.0 Network controller: Broadcom Corporation BCM4312 802.11b/g (rev 01)
...
[ 630.553689] Broadcom 43xx driver loaded [ Features: PMLR,
Firmware-ID: FW13 ]
it seems weird that there is only one line about the b43 module...
The driver is definitely not picking up the card. Here's what it should look like:
[ 2620.611136] b43-phy2: Broadcom 4318 WLAN found (core revision 9)
[ 2620.626037] b43-phy2 debug: Found PHY: Analog 3, Type 2, Revision 7
[ 2620.626062] b43-phy2 debug: Found Radio: Manuf 0x17F, Version 0x2050, Revision 8
[ 2620.636899] phy2: Selected rate control algorithm 'minstrel'
[ 2620.637796] Broadcom 43xx driver loaded [ Features: PLR, Firmware-ID: FW13 ]
It is well documented that b43 + bcm43xx at the same box create
conflicts. It looks as if you have both installed, do you?
I do not. 'Broadcom 43xx' does not refer to bcm43xx, and b43 is
working fine. [I'm not the OP, who's experiencing problems.]
Celejar
--
mailmin.sourceforge.net - remote access via secure (OpenPGP) email
ssuds.sourceforge.net - A Simple Sudoku Solver and Generator
--
To UNSUBSCRIBE, email to debian-user-REQUEST@xxxxxxxxxxxxxxxx
with a subject of "unsubscribe". Trouble? Contact listmaster@xxxxxxxxxxxxxxxx
- Prev by Date: Downloading in iceweasel.
- Next by Date: Re: Downloading in iceweasel.
- Previous by thread: Downloading in iceweasel.
- Next by thread: Re: New installation: Volume Group not found
- Index(es):
Relevant Pages
|
