Re: Failover of gateways



On Thu, Jan 14, 2010 at 01:06:29PM -0300, Daniel Bareiro wrote:
Hi all!

I'm trying to configure Debian GNU/Linux with two alternative gateways.
That is to say, that initially the traffic is by GW1 and if it is down
then it goes by GW2. If GW2 is again up, then it becomes to use GW1.

Somebody was able to implement some configuration of this type and could
help me with it or indicate some reference to me?

Thanks in advance for your replies.

have a look here
http://lartc.org/

linux advanced routing + TC, there is a how to do multi default
gateways.

I previously used this to do a adls2+ and a cable setup, although you
have to devise a test for each gateway. just pinging the gw isn't good
enough, do you do just past the gw ??



Regards,
Daniel



--
You can't take it with you -- especially when crossing a state line.

Attachment: signature.asc
Description: Digital signature



Relevant Pages

  • Re: Failover of gateways
    ... if it is down then it goes by GW2. ... becomes to use GW1. ... or are both gateways on a separate network interface? ...
    (Debian-User)
  • Re: Failover of gateways
    ... gateways. ... if it is down then it goes by GW2. ... becomes to use GW1. ... It is possible to change of active node when the ...
    (Debian-User)
  • Re: Failover of gateways
    ... I'm trying to configure Debian GNU/Linux with two alternative gateways. ... If GW2 is again up, then it becomes to use GW1. ...
    (Debian-User)
  • Re: Failover of gateways
    ... I'm trying to configure Debian GNU/Linux with two alternative gateways. ... If GW2 is again up, then it becomes to use GW1. ... To UNSUBSCRIBE, email to debian-user-REQUEST@xxxxxxxxxxxxxxxx with a subject of "unsubscribe". ...
    (Debian-User)
  • Failover of gateways
    ... I'm trying to configure Debian GNU/Linux with two alternative gateways. ... If GW2 is again up, then it becomes to use GW1. ...
    (Debian-User)