XFree86 error
From: Jeremiah McElroy (jeremiah_at_facility9.com)
Date: 01/24/04
- Previous message: Herculano de Lima Einloft Neto: "Re: bash: any way to reuse the last output?"
- Next in thread: Pedro Fernandes Macedo: "Re: XFree86 error"
- Reply: Pedro Fernandes Macedo: "Re: XFree86 error"
- Maybe reply: Jeremiah McElroy: "RE: XFree86 error"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
To: <fedora-list@redhat.com> Date: Fri, 23 Jan 2004 19:55:31 -0500
I just installed Fedora Core 1 as a clean install. When I try to start X using the PowerVR drivers for my graphics card (which I downloaded and installed), I see the following error in my XFree86.0.log file:
(++) using VT number 7
Fatal server error:
xf86OpenConsole: Cannot open virtual console 7 (Input/output error)
I have never seen this problem in the past. I used to run Red Hat 9.0 and I also built the drivers by hand. I have attached my XF86Config file in case that is needed.
Thanks,
Jeremiah McElroy
-- fedora-list mailing list fedora-list@redhat.com To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list
- Previous message: Herculano de Lima Einloft Neto: "Re: bash: any way to reuse the last output?"
- Next in thread: Pedro Fernandes Macedo: "Re: XFree86 error"
- Reply: Pedro Fernandes Macedo: "Re: XFree86 error"
- Maybe reply: Jeremiah McElroy: "RE: XFree86 error"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
|