RE: Install problem
From: Polashek, Matthew (Matthew.Polashek_at_scottforesman.com)
Date: 03/01/04
- Previous message: Jeff Largent: "Re: Install problem"
- Maybe in reply to: Polashek, Matthew: "Install problem"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
To: "'fedora-list@redhat.com'" <fedora-list@redhat.com> Date: Mon, 01 Mar 2004 14:20:50 -0500
Ok.. thanks. I am starting to figure that out. My vectra had a cable
select IDE cable, hence my confusion.
So this is definitely a fedora/grub/installation problem then.
Matthew Polashek
Associate Editor, Silver Burdett Ginn - Music
Scott Foresman/Pearson Education
299 Jefferson Road
Parsippany, NJ 07054-0480
office: 973.739.8709
fax: 973.739.8098
Matthew.Polashek@scottforesman.com
> ----------
> From: Jeff Largent
> Reply To: fedora-list@redhat.com
> Sent: Monday, March 1, 2004 2:12 PM
> To: fedora-list@redhat.com
> Subject: Re: Install problem
>
> No such thing as wrong order on the ide cable, that is the reason
> for ide master/slave jumpers on ide devices, the device settings
> not the position on ide cable determine which device is first and
> which is second.
>
>
>
> Polashek, Matthew wrote:
> > The FC is using both disks. The installations was fine before adding
> the
> > second disk and configuring the master/slave relationship. (though I
> have
> > been suspecting since I have been here at work that they may be in the
> wrong
> > order on the IDE cable) I have a Biostar m6tba MOBO that seems to
> recognize
> > both disks on startup when it runs a quick memory check and I have set
> the
> > bios to automatically recognize the disks.
> >
> > I recently switched from a slower HP Vectra VL7 in which I had 2 hard
> drives
> > installed and on which I was running fc1 with no problems.
> >
> > Matthew Polashek
> > Associate Editor, Silver Burdett Ginn - Music
> > Scott Foresman/Pearson Education
> > 299 Jefferson Road
> > Parsippany, NJ 07054-0480
> > office: 973.739.8709
> > fax: 973.739.8098
> > Matthew.Polashek@scottforesman.com
> >
> >
> >
> >>----------
> >>From: Mitch Wiedemann
> >>Reply To: fedora-list@redhat.com
> >>Sent: Monday, March 1, 2004 1:47 PM
> >>To: fedora-list@redhat.com
> >>Subject: Re: Install problem
> >>
> >>Is your FC install using both disks? If you remove the second disk,
> >>does it work properly?
> >>Are both disks identified correctly in the BIOS?
> >>
> >>Polashek, Matthew wrote:
> >>
> >>
> >>>I have been able to boot from the Fedora CD and go into rescue mode and
> >>>mount the system under /mnt/sysimage.
> >>>I assume pico, vi, and emacs all run though I haven't tried them. I
> was
> >>>assuming it was a hardware physical configuration error on my part.
> >>>
> >>>I can't remember off hand what partitions are where but I think /boot
> is
> >>
> >>on
> >>
> >>>hda and FC1 root is probably on /hdb2
> >>>
> >>>
> >>
> >>
> >>--
> >>fedora-list mailing list
> >>fedora-list@redhat.com
> >>To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list
> >>
> >>
> >>
> >>
> >
> >
> **************************************************************************
> **
> > This email may contain confidential material.
> > If you were not an intended recipient,
> > please notify the sender and delete all copies.
> > We may monitor email to and from our network.
> >
> >
> **************************************************************************
> **
> >
> >
> >
>
> --
> Jeff Largent ImageLinks, Inc.
>
>
> --
> fedora-list mailing list
> fedora-list@redhat.com
> To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list
>
>
>
>
****************************************************************************
This email may contain confidential material.
If you were not an intended recipient,
please notify the sender and delete all copies.
We may monitor email to and from our network.
****************************************************************************
-- fedora-list mailing list fedora-list@redhat.com To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list
- Previous message: Jeff Largent: "Re: Install problem"
- Maybe in reply to: Polashek, Matthew: "Install problem"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|