How to set up network interface from scratch - newbie

From: Hartono Nugroho (hanugro_at_indo.net.id)
Date: 10/29/04

  • Next message: Leonard Isham: "Re: How to mount samba folder within a NT Domain network?"
    To: <fedora-list@redhat.com>
    Date: Fri, 29 Oct 2004 08:03:08 +0700
    
    
    

    Hi all,

     

    I just install USB wireless device using ndiswrapper and the interface is
    wlan0. I run iwconfig setup (ISSD, key, etc) and wlan0 already recognize my
    router MAC address. I try to set up using network config but my device does
    not show up in the choices.

     

    I have a wireless router that also act as DHCP server. I have another 2 PCs
    running win and linux that is wired to this router. On this particular PC,
    I dual boot win and Fedora2. The win partition already connect to the
    internet using this USB device. So I want to set up the Linux partition to
    use DHCP as well in waln0 interface in this machine.

     

    Up to this point I, if I do ifconfig it is only showing lo. Could ppl
    please tell me how to setup linux so that it will use wlan0 as my network
    interface and receive DHCP info from my router?

     

    TIA for your info.

    
    

    -- 
    fedora-list mailing list
    fedora-list@redhat.com
    To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list
    

  • Next message: Leonard Isham: "Re: How to mount samba folder within a NT Domain network?"

    Relevant Pages

    • [Full-Disclosure] FW: Cisco Vulnerability forensic protocol analysis results.
      ... AMILABS CISCO IP PROTOCOL EXPLOIT TESTING RESULTS ... Cisco router interfaces using either all or one of the following IP ... of a remote Cisco interface uses all of them. ... output buffer failures, 0 output buffers swapped out Router4# ...
      (Full-Disclosure)
    • Re: Site-to-Site VPN client routing question - clients at branch office not able to acce
      ... I would recommend that you use some other machine as your router, ... select the demand-dial interface from the dropdown list. ... On the RRAS server in Shanghai, configure a demand-dial interface and give it a static route to 194.1.1.0/24 as above. ... This makes sure that the connection is made to the correct dd interface and sets up the correct route back to Shanghai through the VPN link. ...
      (microsoft.public.windows.server.networking)
    • Point to Point T1 with Cisco 1841 Routers
      ... checked it in the morning and on my side, the router had a lot of CRC ... interface FastEthernet0/0 ... ip http access-class 23 ... minute output rate 0 bits/sec, 0 packets/sec ...
      (comp.dcom.sys.cisco)
    • Re: moved a working network, now it doesnt work
      ... router I can ping the internet with no problem. ... From one of your Linux machines can you ping the FA 0/1 interface (default ... are NOT natting so if CAN ping from the router, ...
      (comp.dcom.sys.cisco)
    • Re: Nmap questions concering my router
      ... >interface can only have assigned ip address and no more. ... but isnt this also the same concept a Port translation is? ... network services externally where the server is on am internal host. ... If someone connected to port 80 on your router, ...
      (comp.security.firewalls)