Re: Hard drive cable question -



bobgoodwin wrote:

Does it matter which forty pin connector plugs into the master and slave drives?
I have come to the realization after struggling with some problems that there are a lot more wires in the ribbon cable than there are connector pins.

If you have more wires than pins, you almost surely have a CABLE SELECT
cable. In fact, if your cable is less than five years old, you probably
have CS. Which end goes where depends on how you jumper your hard
drives.

I now see that Maxtor designates the connector at the end of the cable as the "master" and the one just below it as the "slave." I presently have only one drive jumpered as master with FC4 running on it and it

If you use M/S jumpering on the drives, then in theory it doesn't matter
where you connect them.

;doesn't seem to care which data cable connector is attached to it, but when I put in the second drive, jumpered as "slave" the computer won't boot. I decided the drive was bad but now I'm wondering? It may be the wrong connectors plugged into the drives.

I thought "cable select" cables had wires obviously crossed in the ribbon cable but that may not be true with this 80 wire ribbon?

Not crossed. For CS, the drives have resistive pull-ups on them. The MB
pulls down one line. The wire to this line is *severed* as the slave
connector, so the "master" sees a high, while the "slave" sees
a low on this pin. (The MB may have a pull-up and the drives
a pull-down, I forget the polarity.)

Floppies have a "twist" in their cables, not hard drives.

Can someone clear this up for me.

HTH

Mike
--
p="p=%c%s%c;main(){printf(p,34,p,34);}";main(){printf(p,34,p,34);}
This message made from 100% recycled bits.
You have found the bank of Larn.
I can explain it for you, but I can't understand it for you.
I speak only for myself, and I am unanimous in that!

--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list



Relevant Pages

  • Re: Hard drive cable question -
    ... All IDE 40/80 pin cables are straight through, ... itself govens whether it's master or slave. ... It's completely wrong to say that all IDE 40 or 80 wire cables are wired ... I've seen drives which need no jumper for master, one jumper for it, two ...
    (Fedora)
  • Re: Hard drive cable question -
    ... All IDE 40/80 pin cables are straight through, ... itself govens whether it's master or slave. ... It's completely wrong to say that all IDE 40 or 80 wire cables are wired ... I've seen drives which need no jumper for master, one jumper for it, two ...
    (Fedora)
  • Re: slave h/d?
    ... usually called ribbon cables because they look like broad ribbons. ... There are two plugs for such things as harddrives and CD drives on ... plug in the middle of the ribbon cable is the "slave" position. ...
    (microsoft.public.windowsxp.general)
  • Re: Hard drive cable question -
    ... slave drives? ... I have come to the realization after struggling with some problems that there are a lot more wires in the ribbon cable than there are connector pins. ... cable as the "master" and the one just below it as the "slave." ... The drives can be jumpered for CS and I have 80 wire ribbon cables so it appears that should work if I understand everything I've read here? ...
    (Fedora)
  • Re: XP killed my new harddrives
    ... around on the cables. ... IDE drives can typically be pinned to be master or slave or use Cable ...
    (microsoft.public.windowsxp.general)