Re: Problems w/ serial flow control
- From: Tim <ignored_mailbox@xxxxxxxxxxxx>
- Date: Wed, 31 May 2006 21:39:43 +0930
On Tue, 2006-05-30 at 21:25 -0600, Philip Prindeville wrote:
I'm running FC3 on an MSI-7142 (K8MM-V motherboard), and using
the two serial ports on the m/b. I used the stock
out-of-the-shrinkwrap settings for most hardware (except for the sound
board and X drivers), and things have worked fine.
But... when connecting to a router's console at 115200 with either
RTS/CTS or XON/XOFF flow control, I'm seeing dropped characters.
Looking at a friend's router, his one's serial port connection *ONLY*
had the three-wire type of serial connection. So his couldn't possibly
use hardware handshaking (RTS/CTS). Perhaps yours can't too?
Also, check what your router says about its maximum port speeds and
handshaking protocols.
--
(Currently running FC4, occasionally trying FC5.)
Don't send private replies to my address, the mailbox is ignored.
I read messages from the public lists.
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
- Follow-Ups:
- Re: Problems w/ serial flow control
- From: Philip Prindeville
- Re: Problems w/ serial flow control
- References:
- Problems w/ serial flow control
- From: Philip Prindeville
- Problems w/ serial flow control
- Prev by Date: [OT] routing
- Next by Date: Re: OT question about time tracking consultant software
- Previous by thread: Problems w/ serial flow control
- Next by thread: Re: Problems w/ serial flow control
- Index(es):
Relevant Pages
|
