Re: New Motherboard Install

On 6/30/06, John Austin <ja@xxxxxxxxxx> wrote:
I have done this very thing this week.
New MB with the same CPU, memory and disk.
FC5 sorted everything out on the first boot.
I did use the same Graphics card though.
Magic

What do you guys count as the "same CPU"? Same physical chip or a
general equivalent?

Physically, I plan to change both the MB and the CPU chip. However
the old chip was a P4 and the new chip is a P4. The speed and some
other details will obviously be different. I am choosing to go this
route instead of making the jump to a AMD 64. I am not ready

Fry's special today is a ECS P4M800PRO-M w/Intel P4 506. Admittedly,
this is low-end compared to what is popular now, but is more than
adequate for my needs and I think is the simplest MB/CPU upgrade path.

--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list

Relevant Pages

  • Re: New Motherboard Install
    ... I have brought up redhat after a moterboard and CPU change just fine. ... New MB with the same CPU, memory and disk. ... FC5 sorted everything out on the first boot. ...
    (Fedora)
  • Re: Dead A7V333 (maybe) - how do I tell ?
    ... sink/fan off the CPU. ... cool the CPU chip with a few seconds ... Then apply power and see if you get any beeps. ... point - then hit the CPU with the freeze spray until it frosts over or (and ...
    (alt.comp.periphs.mainboard.asus)
  • Re: Dead A7V333 (maybe) - how do I tell ?
    ... the one question you have - is it the mb or the CPU if it's not something ... using some coolant (freeze) spray. ... cool the CPU chip with a few seconds ... point - then hit the CPU with the freeze spray until it frosts over or (and ...
    (alt.comp.periphs.mainboard.asus)
  • Re: Sys 80 bootup issue
    ... volts at pin 40 of U1 (I've replaced this chip btw). ... before voltage truly stabilized and the CPU was ready. ... working when my voltage is lower. ...
    (rec.games.pinball)
  • Re: Sys 80 bootup issue
    ... volts at pin 40 of U1 (I've replaced this chip btw). ... before voltage truly stabilized and the CPU was ready. ... working when my voltage is lower. ... with the lack of logic state data provided I cannot offer any more guesses. ...
    (rec.games.pinball)