Re: F8 installation in external usb disk (not USB key)

Ok, I'll try again this time writing down all the steps and repost
with the exact error. But I'll check, as you propose, the devices
in /etc/fstab and /boot/grub/grub.conf

Thank you!

Regards,
Miguel

2007/12/31, Mikkel L. Ellertson <mikkel@xxxxxxxxxxxxxxxx>:
Miguel Blanco wrote:
Yes, you are rigth about the standard install and the BIOS drives remaps!

I tried configuring GRUB in the MBR of the external disk, and the procedure
described in the refered paper failed at the last point, ie. the kernel output
a lot of errors and failed to boot...

Thanks for your comments!

Regards,
Miguel.

If you get to the point where the kernel loads, and produces errors,
then the problem is ether in /etc/fstab or in /boot/grub/grub.conf.
Without knowing the errors, it is hard to tell. It probably is a
problem with the root device passed to the kernel from Grub. If you
are not using LVM, then the root device is probably something like
/dev/sdb5 and needs to be changed to /dev/sda5. (The 5 may not be
correct.) You may need to do the same thing in /etc/fstab. The
reason for this is that the usb_storage module is loaded from
initrd, so it becomes the first SCSI controller.

A better way to handle it is to give all the partitions on the USB
drive labels, and use the labels instead of the device names. That
way, it does not matter what drive letter is assigned to the drive.

Mikkel
--

Do not meddle in the affairs of dragons,
for thou art crunchy and taste good with Ketchup!


--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list



--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list

Relevant Pages

  • Re: F8 installation in external usb disk (not USB key)
    ... I tried configuring GRUB in the MBR of the external disk, ... If you get to the point where the kernel loads, and produces errors, ... problem with the root device passed to the kernel from Grub. ... drive labels, and use the labels instead of the device names. ...
    (Fedora)
  • Re: debian sarge 2.6.11 kernel?
    ... >> root device and fs ... > His boot loader loaded the kernel via BIOS calls. ... when I was trying to compile the kernel from kernel.org. ... My laptop is a P150 but my workstation is just a PII/450. ...
    (comp.os.linux.misc)
  • Initial ramdisk support does not work (for me) on 2.6.17.13
    ... We are building embedded devices based on Linux and we use a ramdisk as ... our root device in order to avoid problems with people switching off the ... Using a 2.6.12 kernel it was no problem to boot the system by using this ...
    (Linux-Kernel)
  • Re: Unable to boot recent -stable with MSI/MSIX enabled
    ... It failed to mount its root device ... The kernel is a GENERIC amd64 kernel plus 'device puc'. ... believe that the new MSI support in the em driver upsets the ATA driver. ... I remember someone having problems with remote boot/mounts at some ...
    (freebsd-stable)
  • Re: Initial ramdisk support does not work (for me) on 2.6.17.13
    ... our root device in order to avoid problems with people switching off the ... Using a 2.6.12 kernel it was no problem to boot the system by using this ...
    (Linux-Kernel)