Re: FC8 (32-bit) screen dimming



David Timms <dtimms@xxxxxxxxxxxx> writes:

Phillip wrote:
On upgrading from FC6 to FC8 on my laptop, the screen dims almost
immediately at the beginning of the boot up sequence. The screen is
bright for any length of time until the messages shows that the
kernel is booting. Then the screen dims so that text and graphics
are barely discernible. This is true in text as well as graphics
modes (runlevels 3 and 5).

Does anyone know what setup file may be causing this?
Could be to do with the screen saver - it fades the X gui out before
it starts the screen saver ?

Could be that it's sensing low battery power and trying to save power ?

Could be that during boot up ntpd resets the time forward, and the
screen saver noitices there has been no activity for X minutes and
starts the fade out.

DaveT.

I can't speak directly to the console mode issues, as I have not noted
this behavior there, but when running in X, there is a setting in:

System -> Preferences -> System -> Power Management

where there is a check box labelled: "Dim display when idle".

I believe that this is checked by default.

Uncheck it and you should be back to normal behavior.

The one thing that I have noted is that when running in TwinView on my
laptop, with an external LCD display connected, only the internal LCD panel
is affected by the setting. Perhaps this is expected or a bug in the
nVidia driver. Either way, I have disabled the behavior for "On AC
Power" and have it enabled for "On Batter Power".

HTH,

Marc Schwartz

--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list



Relevant Pages

  • Re: re visited Green Screen - warning, a long ramble
    ... If you can't Boot your PC up, then you aren't going to be able ... It might be an idea to go into the BIOS & Set the "ReSet ESCD" ... Though that's really just the BIOS working through the POST - Power ... She went on to install 5updates and then shut down normally. ...
    (uk.people.silversurfers)
  • Re: asrock, problem with nic after windows-boot - Exact Opposite issue the OP is having
    ... I never use/used a power strip in that manner (for *ATX* ... lacks upon a warm boot. ... $ sudo apt-get install sag ... Reading Package Lists... ...
    (comp.os.linux.networking)
  • Re: emachines w3107 question
    ... you use the PC and does boot time matter to you. ... a computer "Fully Awake & Running" consumes power similar to ... She rebooted several times and a couple of times " Windows ... Better computer manufacturers provide comprehensive hardware ...
    (microsoft.public.windowsxp.general)
  • Re: Fast Start-up
    ... It genuinely has valid requirements for the power issues. ... To give me some idea - Is the CE suspend state the same as used by a WM5 ... accidentally drain that battery. ... Faster processors generally boot faster. ...
    (microsoft.public.windowsce.embedded)
  • Re: Boot fail -- missing file
    ... I will investigate the power supply. ... P.S Could you boot to any mode like safe Mode or Normal mode?. ... If you are using Windows XP Home ... 9- Then type bootcfg /rebuild ...
    (microsoft.public.windowsxp.general)