SELinux



Hello,

With fedora 13, when I use Math:GSL, I get an error message:
Can't load '/usr/local/lib/perl5/auto/Math/GSL/Errno/Errno.so' for module Math::GSL::Errno: /usr/local/lib/perl5/auto/Math/GSL/Errno/Errno.so: cannot restore segment prot after reloc: Permission denied at /usr/lib/perl5/DynaLoader.pm line 200.

if I do not switch SELinux to permissive !!

IE I cannot use enforcing

--
---
==========================================================================
Patrick DUPRÉ | |
Department of Chemistry | | Phone: (44)-(0)-1904-434384
The University of York | | Fax: (44)-(0)-1904-432516
Heslington | |
York YO10 5DD United Kingdom | | email: pd520@xxxxxxxxxx
==========================================================================--
users mailing list
users@xxxxxxxxxxxxxxxxxxxxxxx
To unsubscribe or change subscription options:
https://admin.fedoraproject.org/mailman/listinfo/users
Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines


Relevant Pages

  • Re: Matlab 2007a on Fedora 8
    ... I have installed Matlab2007a on Fedora 8 x86_64. ... However when I try to run it I get the following error message ... libguide.so: cannot restore segment prot after reloc: Permission ...
    (comp.soft-sys.matlab)
  • Re: Matlab 2007a on Fedora 8
    ... However when I try to run it I get the following error message ... libguide.so: cannot restore segment prot after reloc: Permission ... That looks like an selinux issue. ...
    (comp.soft-sys.matlab)
  • Matlab 2007a on Fedora 8
    ... I have installed Matlab2007a on Fedora 8 x86_64. ... However when I try to run it I get the following error message ... libguide.so: cannot restore segment prot after reloc: Permission ...
    (comp.soft-sys.matlab)
  • Re: SELinux
    ... With fedora 13, when I use Math:GSL, I get an error message: ... cannot restore segment prot after reloc: ...
    (Fedora)
  • Re: linux install for matlab
    ... All my time looking at searches for glnx64 was pretty fruitless. ... > cannot restore segment prot after reloc: ... Searching for "cannot restore segment prot after reloc" on the support website, http://www.mathworks.com/support, found three hits, one of which is titled "Why do I receive errors relating to the file "libmwlapack" when starting MATLAB 7.0.1 or higher on Linux?" ...
    (comp.soft-sys.matlab)