Re: TG3: very high CPU usage
From: JG (jg_at_cms.ac)
Date: 01/31/04
- Previous message: Nigel Cunningham: "Re: [Swsusp-devel] Software Suspend 2.0"
- In reply to: JG: "Re: TG3: very high CPU usage"
- Next in thread: Tom Sightler: "Re: TG3: very high CPU usage"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Sat, 31 Jan 2004 10:15:51 +0100 To: Lincoln Dale <ltd@cisco.com>
hi,
i'm replying to my email.
> thank you for the info! i searched their site, but i only found a reference to BACS on their faq page and that this software should be on their driver cdrom (well, it is not on my netgear cdrom).
> but i'll test my cable with a fluke networks cable tester tomorrorw or on tuesday. i'll post the results if they are relevant.
well, i did a thorough cable test with a DSP-4100 fluke networks cable tester and i had some bad values. i've been using 3 cables (24m) with adapters, all single cables were fine, so the adapters seemed to cause the problem.
but i'm now using a longer x-over cable (30m) where i also get those speed problems. it is a *bit* better, i get about 1-2MB/s in both directions, but i'm also experiencing a very high error rate over the x-over cable...(~40-50 errors per second)
do you have this BACS software and is it possible to test the NIC itself with it? maybe one of my NICs is causing this.
thx,
JG
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
- application/pgp-signature attachment: stored
- Previous message: Nigel Cunningham: "Re: [Swsusp-devel] Software Suspend 2.0"
- In reply to: JG: "Re: TG3: very high CPU usage"
- Next in thread: Tom Sightler: "Re: TG3: very high CPU usage"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
|
