Re: KERNEL 2.6.3 and MAXTOR 160 GB

• Previous message: David B. Stevens: "Re: KERNEL 2.6.3 and MAXTOR 160 GB"
• In reply to: Carlo Orecchia: "Re: KERNEL 2.6.3 and MAXTOR 160 GB"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

To: Carlo Orecchia <carlo@numb.darktech.org>, "David B. Stevens" <dsteven3@maine.rr.com>
Date:	Mon, 8 Mar 2004 01:09:05 +0100

On Sunday 07 of March 2004 23:26, Carlo Orecchia wrote:
> Sorry my stupid mistake .. this is the correct message from boot:
> Thanks for any reply!!
>
> ide: Assuming 33MHz system bus speed for PIO modes; override with
> idebus=xx
> ALI15X3: IDE controller at PCI slot 0000:00:04.0
> ACPI: No IRQ known for interrupt pin A of device 0000:00:04.0 - using IRQ
> 255
> ALI15X3: chipset revision 196
> ALI15X3: not 100% native mode: will probe irqs later
> ide0: BM-DMA at 0xb400-0xb407, BIOS settings: hda:DMA, hdb:pio
> ide1: BM-DMA at 0xb408-0xb40f, BIOS settings: hdc:pio, hdd:pio
> hda: Maxtor 6Y160P0, ATA DISK drive
> ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
> hdc: no response (status = 0xa1), resetting drive
> hdc: no response (status = 0xa1)
> hdd: no response (status = 0xa1), resetting drive
> hdd: no response (status = 0xa1)
> hdc: no response (status = 0xa1), resetting drive
> hdc: no response (status = 0xa1)
> hdd: no response (status = 0xa1), resetting drive
> hdd: no response (status = 0xa1)
> hda: max request size: 128KiB
> hda: cannot use LBA48 - full capacity 320173056 sectors (163928 MB)
> hda: 268435456 sectors (137438 MB) w/7936KiB Cache, CHS=16709/255/63,
> UDMA(100)

Your IDE controller doesn't support DMA transfer modes when LBA48 is used.
This means that access to the > 137GB part of the disk can only be done
using PIO modes (slow!).

Patch below (against kernel 2.6.4-rc2) should fix access to >137GB part
of the disk in the best possible way - IDE driver will always try to use
DMA and revert to PIO only when necessary. I dunno what patches are
included in RedHat's 2.4.20-8 but kernels < 2.4.23 can silently corrupt
your data because of this issue (and you still won't access whole disk
with >= 2.4.23, although -ac tree contained fix which just turned DMA off).

> # CONFIG_IDE_TASKFILE_IO is not set

Please don't set it to 'y' while using this patch (because it's harder to
fix for CONFIG_IDE_TASKFILE_IO and conflicts with other pending patches).

Regards,
Bartlomiej

 linux-2.6.4-rc2-root/drivers/ide/ide-disk.c | 29 +++++++++++++++++-------
 linux-2.6.4-rc2-root/drivers/ide/ide-probe.c | 8 ++++--
 linux-2.6.4-rc2-root/drivers/ide/pci/alim15x3.c | 4 +--
 linux-2.6.4-rc2-root/include/linux/ide.h | 1
 4 files changed, 30 insertions(+), 12 deletions(-)

diff -puN drivers/ide/ide-disk.c~ide_no_lba48_dma drivers/ide/ide-disk.c
--- linux-2.6.4-rc2/drivers/ide/ide-disk.c~ide_no_lba48_dma 2004-03-08 00:07:38.518961600 +0100
+++ linux-2.6.4-rc2-root/drivers/ide/ide-disk.c 2004-03-08 00:51:05.705608984 +0100
@@ -470,12 +470,15 @@ ide_startstop_t __ide_do_rw_disk (ide_dr
         }
 
         if (rq_data_dir(rq) == READ) {
+ if (!drive->hwif->no_lba48_dma ||
+ rq->sector + rq->nr_sectors < 1ULL << 28) {
 #ifdef CONFIG_BLK_DEV_IDE_TCQ
- if (blk_rq_tagged(rq))
- return __ide_dma_queued_read(drive);
+ if (blk_rq_tagged(rq))
+ return __ide_dma_queued_read(drive);
 #endif
- if (drive->using_dma && !hwif->ide_dma_read(drive))
- return ide_started;
+ if (drive->using_dma && !hwif->ide_dma_read(drive))
+ return ide_started;
+ }
 
                 command = ((drive->mult_count) ?
                            ((lba48) ? WIN_MULTREAD_EXT : WIN_MULTREAD) :
@@ -484,12 +487,16 @@ ide_startstop_t __ide_do_rw_disk (ide_dr
                 return ide_started;
         } else if (rq_data_dir(rq) == WRITE) {
                 ide_startstop_t startstop;
+
+ if (!drive->hwif->no_lba48_dma ||
+ rq->sector + rq->nr_sectors < 1ULL << 28) {
 #ifdef CONFIG_BLK_DEV_IDE_TCQ
- if (blk_rq_tagged(rq))
- return __ide_dma_queued_write(drive);
+ if (blk_rq_tagged(rq))
+ return __ide_dma_queued_write(drive);
 #endif
- if (drive->using_dma && !(HWIF(drive)->ide_dma_write(drive)))
- return ide_started;
+ if (drive->using_dma && !hwif->ide_dma_write(drive))
+ return ide_started;
+ }
 
                 command = ((drive->mult_count) ?
                            ((lba48) ? WIN_MULTWRITE_EXT : WIN_MULTWRITE) :
@@ -1601,6 +1608,12 @@ static void idedisk_setup (ide_drive_t *
                 drive->capacity64 = 1ULL << 28;
         }
 
+ if (drive->hwif->no_lba48_dma && drive->capacity64 > 1ULL << 28) {
+ printk(KERN_INFO "%s: cannot use LBA48 DMA - PIO mode will be"
+ "used for accessing sectors > %u\n",
+ drive->name, 1 << 28);
+ }
+
         /*
          * if possible, give fdisk access to more of the drive,
          * by correcting bios_cyls:
diff -puN drivers/ide/ide-probe.c~ide_no_lba48_dma drivers/ide/ide-probe.c
--- linux-2.6.4-rc2/drivers/ide/ide-probe.c~ide_no_lba48_dma 2004-03-08 00:07:38.522960992 +0100
+++ linux-2.6.4-rc2-root/drivers/ide/ide-probe.c 2004-03-08 00:07:38.531959624 +0100
@@ -922,8 +922,12 @@ static int ide_init_queue(ide_drive_t *d
         q->queuedata = HWGROUP(drive);
         blk_queue_segment_boundary(q, 0xffff);
 
- if (!hwif->rqsize)
- hwif->rqsize = hwif->no_lba48 ? 256 : 65536;
+ if (!hwif->rqsize) {
+ if (hwif->no_lba48 || hwif->no_lba48_dma)
+ hwif->rqsize = 256;
+ else
+ hwif->rqsize = 65536;
+ }
         if (hwif->rqsize < max_sectors)
                 max_sectors = hwif->rqsize;
         blk_queue_max_sectors(q, max_sectors);
diff -puN drivers/ide/pci/alim15x3.c~ide_no_lba48_dma drivers/ide/pci/alim15x3.c
--- linux-2.6.4-rc2/drivers/ide/pci/alim15x3.c~ide_no_lba48_dma 2004-03-08 00:07:38.504963728 +0100
+++ linux-2.6.4-rc2-root/drivers/ide/pci/alim15x3.c 2004-03-08 00:07:38.526960384 +0100
@@ -752,8 +752,8 @@ static void __init init_hwif_common_ali1
         hwif->tuneproc = &ali15x3_tune_drive;
         hwif->speedproc = &ali15x3_tune_chipset;
 
- /* Don't use LBA48 on ALi devices before rev 0xC5 */
- hwif->no_lba48 = (m5229_revision <= 0xC4) ? 1 : 0;
+ /* don't use LBA48 DMA on ALi devices before rev 0xC5 */
+ hwif->no_lba48_dma = (m5229_revision <= 0xC4) ? 1 : 0;
 
         if (!hwif->dma_base) {
                 hwif->drives[0].autotune = 1;
diff -puN include/linux/ide.h~ide_no_lba48_dma include/linux/ide.h
--- linux-2.6.4-rc2/include/linux/ide.h~ide_no_lba48_dma 2004-03-08 00:07:38.515962056 +0100
+++ linux-2.6.4-rc2-root/include/linux/ide.h 2004-03-08 00:07:38.527960232 +0100
@@ -980,6 +980,7 @@ typedef struct hwif_s {
         unsigned autodma : 1; /* auto-attempt using DMA at boot */
         unsigned udma_four : 1; /* 1=ATA-66 capable, 0=default */
         unsigned no_lba48 : 1; /* 1 = cannot do LBA48 */
+ unsigned no_lba48_dma : 1; /* 1 = cannot do LBA48 DMA */
         unsigned no_dsc : 1; /* 0 default, 1 dsc_overlap disabled */
         unsigned auto_poll : 1; /* supports nop auto-poll */
 

_

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

• Previous message: David B. Stevens: "Re: KERNEL 2.6.3 and MAXTOR 160 GB"
• In reply to: Carlo Orecchia: "Re: KERNEL 2.6.3 and MAXTOR 160 GB"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]