Re: [ACPI] Re: Video memory corruption during suspend

From: Karol Kozimor (sziwan_at_hell.org.pl)
Date: 07/22/04

  • Next message: Andrew Chew: "[PATCH 2.6.8-rc2] sata_nv.c"
    Date:	Thu, 22 Jul 2004 23:28:03 +0200
    To: Pavel Machek <pavel@ucw.cz>
    
    

    Thus wrote Pavel Machek:
    > > My setup is:
    > > ASUS L3800C laptop, Radeon M7, i845 chipset, using DRI and radeonfb.
    [...]
    > So what happens on 2.6.7 with swsusp1? Can you try vesafb (and fbdev
    > Xserver)?

    I don't have 2.6.7-vanilla at hand, but if 2.6.7-mm6 counts then yes,
    swsusp1 also triggers that. Note that it doesn't seem to occur when DRI is
    not actively used -- the radeon driver code takes quite a long time (up to
    4 secs.) to switch to a text VT depending on circumstances, namely when KDE
    is up. A plain windowmaker dekstop takes much shorter to switch.

    As I'm leaving tomorrow, I won't have time to test with vesafb / fbdev
    until next week.

    Best regards,

    -- 
    Karol 'sziwan' Kozimor
    sziwan@hell.org.pl
    -
    To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
    the body of a message to majordomo@vger.kernel.org
    More majordomo info at  http://vger.kernel.org/majordomo-info.html
    Please read the FAQ at  http://www.tux.org/lkml/
    

  • Next message: Andrew Chew: "[PATCH 2.6.8-rc2] sata_nv.c"

    Relevant Pages

    • Re: Ideas for low voltage sound activated switch
      ... > mechanical action, so if the nylon is melted, the action takes place. ... I would not go with button cells as such, ... > 2) Sound at a specific frequency triggers the switch. ...
      (sci.electronics.design)
    • Re: Need help with intermittent circuit failures - JK Flip Flops
      ... monostable triggers automatically. ... separate circuit to achieve that as well - the negative pulse. ... long the reed is in contact with the magnet for. ... Assuming a normally open reed switch, ...
      (sci.electronics.basics)
    • Re: Timed relay control
      ... The NC contacts on the limit switch then open and the ... relay unlatches. ... supplies air to the triggers on the nail guns. ... All gun manufacturers manufacture "remote triggers" ...
      (rec.crafts.metalworking)
    • Re: [RFC] ethtool semantics
      ... I find the c) feature very convenient. ... the configuration of the switch, something which is usually (pick your ... Command line parameters of the bcm5700 driver do implement c) (among ... send the line "unsubscribe linux-kernel" in ...
      (Linux-Kernel)
    • Re: [PROPOSAL/PATCH] Remove PT_GNU_STACK support before 2.6.11
      ... It wasnt a bump-free ride, ... But if it triggers it shows up immediately so it's not like you ... that's what caused grub-install being used in an NX ... send the line "unsubscribe linux-kernel" in ...
      (Linux-Kernel)