Re: [OT] 8-port AHCI SATA Controller?
- From: Joshua Kugler <joshua.kugler@xxxxxxx>
- Date: Tue, 31 Jan 2006 09:19:19 -0900
On Tuesday 31 January 2006 02:53, Sander wrote:
> Hello,
>
> I'm looking for an 8-port SATA controller based on the AHCI chipset, as
> according to http://linux.yyz.us/sata/sata-status.html#vendor_support
> this chipset is completely open.
>
> I've searched the websides of the companies which according to
> http://linux.yyz.us/sata/sata-status.html#ahci base some of their
> products on this chipset, but I couldn't find an 8-port controller.
>
> I've also googled, but without success, hence this somewhat offtopic
> message. Although I hope the response helps others in their quest.
>
> The question: does an 8-port AHCI based SATA controller exist? And if,
> where can I find it? 12, 16 or 24 ports will do too. I don't need HW
> raid, just JBOD.
I've run some tests with this card under Linux and done pretty well:
http://www.supermicro.com/products/accessories/addon/DAC-SATA-MV8.cfm
They also have a 3.0Gb version.
Not sure if that is AHCI, but it is eight port.
I got the drivers here:
http://www.keffective.com/mvsata/FC3/
The latest was mvSata_Linux_3.6.1.tgz as of 2005-10-13.
Hope that helps.
j----- k-----
--
Joshua Kugler PGP Key: http://pgp.mit.edu/
CDE System Administrator ID 0xDB26D7CE
http://distance.uaf.edu/
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
- Follow-Ups:
- Re: [OT] 8-port AHCI SATA Controller?
- From: Sander
- Re: [OT] 8-port AHCI SATA Controller?
- References:
- [OT] 8-port AHCI SATA Controller?
- From: Sander
- [OT] 8-port AHCI SATA Controller?
- Prev by Date: Re: GPL V3 and Linux - Dead Copyright Holders
- Next by Date: w83791d sensor support
- Previous by thread: Re: [OT] 8-port AHCI SATA Controller?
- Next by thread: Re: [OT] 8-port AHCI SATA Controller?
- Index(es):
Relevant Pages
- [opensuse] 10.3 hardware support question
... Anyone know of issues with using an intel 3210 chipset and a intel ICH9R ...
SATA controller with openSUSE 10.3 'out of the box'? ... our system supplier only
has the latest. ... (SuSE) - Re: ata_piix failure on ich6m
... ata_piix attempts to drive the chipset, but fails - however, it doesn't bail out. ...
As a result it remains bound to the device and ahci isn't loaded. ... I've attached the
lspci output for the chipset. ... The SCC register identifies it as an AHCI controller
... (Linux-Kernel) - Re: ata_piix failure on ich6m
... ata_piix attempts to drive the chipset, but fails - however, it doesn't bail out. ...
As a result it remains bound to the device and ahci isn't loaded. ... I've attached the
lspci output for the chipset. ... that could be the correct solution but I'm a bit worried
because it could change probing order or fail to enable devices it used to. ... (Linux-Kernel) - Re: Windows XP Installation hangs at the "Setup is starting windows" message
... This would normally come from the maker of the SATA controller, which is probably the
main chipset. ... So you might find it at, for example, the Via or AMDweb site (not sure what
chipset that computer uses). ... But the installation hangs, freezes, stops ...
CD-ROM is Dell version of Windows XP Pro with Service Pack 2 ... (alt.sys.pc-clone.dell) - ata_piix failure on ich6m
... it remains bound to the device and ahci isn't loaded. ... I've attached the
lspci output for the chipset. ... the port is to be controlled as an ahci device.
... low) -> IRQ 233 ... (Linux-Kernel)