LibPATA code issues / 2.6.15.4
- From: Justin Piszcz <jpiszcz@xxxxxxxxxxxxxxx>
- Date: Tue, 14 Feb 2006 04:48:31 -0500 (EST)
Jeff,
I'd have to double check but I do not recall getting these errors before the pass-thru code was introduced in 2.6.15, I also was not running the smart daemon until 2.6.15 for SATA drives as it was not supported.
I had a few issues before that I posted to LKML, those were due to too many SATA devices etc, everything is back to normal for the most part.
Speed, etc, all is well again, almost...
/dev/sdc:
Timing buffered disk reads: 154 MB in 3.02 seconds = 50.97 MB/sec
/dev/sdc:
Timing buffered disk reads: 162 MB in 3.00 seconds = 53.94 MB/sec
The only issue I have is when I copy a lot of files to a WD 400GB drive I these pesky errors in dmesg:
ata3: translated ATA stat/err 0x51/04 to SCSI SK/ASC/ASCQ 0xb/00/00
ata3: status=0x51 { DriveReady SeekComplete Error }
ata3: error=0x04 { DriveStatusError }
Yet, everything copied (226GB) or so to the 400GB drive without a single I/O error that I am aware of. So my question is, why do I get these errors in dmesg if they are not critical?
Thanks,
Justin.
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
- Follow-Ups:
- Re: LibPATA code issues / 2.6.15.4
- From: Mark Lord
- Re: LibPATA code issues / 2.6.15.4
- Prev by Date: Re: [patch 1/2] fix perf. bug in wake-up load balancing for aim7 and db workload
- Next by Date: [PATCH] unify pfn_to_page take3 [0/23]
- Previous by thread: 2.6.16-rc3-mm1
- Next by thread: Re: LibPATA code issues / 2.6.15.4
- Index(es):
Relevant Pages
|
|
