Natsemi DP83815 driver spaming
- From: Rafał Bilski <rafalbilski@xxxxxxxxxx>
- Date: Mon, 30 Apr 2007 22:58:47 +0200
Hello,
I have Wyse 3360SE terminal running Linux 2.6.21-rc7. Everything
works great with one small exception. Natsemi DP83815 driver is
filling log with:
ezri user.info kernel: eth0: DSPCFG accepted after 0 usec.every 5 seconds. I can comment out these messages, but I would
ezri user.notice kernel: eth0: Wake-up event 0x80000a
ezri user.info kernel: eth0: Setting full-duplex based on negotiated link capability.
like to turn off the source of wake up event. It is a bit
strange to see wakeup event on running system.
Please CC me.
Thank You
Rafał
natsemi dp8381x driver, version 2.1, Sept 11, 2006
originally by Donald Becker <becker@xxxxxxxxx>
http://www.scyld.com/network/natsemi.html
2.4.x kernel port by Jeff Garzik, Tjeerd Mulder
PCI: Setting latency timer of device 0000:00:0f.0 to 64
natsemi eth0: NatSemi DP8381[56] at 0x10010000 (0000:00:0f.0), 00:80:64:10:c6:09, IRQ 10, port TP.
00:0f.0 Ethernet controller: National Semiconductor Corporation DP83815 (MacPhyter) Ethernet Controller
Subsystem: National Semiconductor Corporation DP83815 (MacPhyter) Ethernet Controller
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (2750ns min, 13000ns max)
Interrupt: pin A routed to IRQ 10
Region 0: I/O ports at f800 [size=256]
Region 1: Memory at 10010000 (32-bit, non-prefetchable) [size=4K]
[virtual] Expansion ROM at 10000000 [disabled] [size=64K]
Capabilities: [40] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=320mA PME(D0+,D1+,D2+,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME+
----------------------------------------------------------------------
NIE KUPUJ!!!
...zanim nie porownasz cen >> http://link.interia.pl/f1a5e
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
- Prev by Date: Re: [PATCH 09/12] i386/x86_64: EHCI usb debug port early printk support.
- Next by Date: Re: [patch] pm: include EIO from errno-base.h
- Previous by thread: [BUG] 2.6.21: Kernel won't boot with either/both of CONFIG_NO_HZ, CONFIG_HIGH_RES_TIMERS
- Next by thread: DST/BT878 module customization (.. was: Critical points about ...)
- Index(es):
Relevant Pages
|
