Re: Monitor problem in RH9.0

• Previous message: Nitin: "Re: how to use tar with scp"
• Maybe in reply to: Tom Klem: "Monitor problem in RH9.0"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

To: redhat-list@redhat.com
Date: Fri, 14 Nov 2003 07:21:43 -0600

Hi, Tom.

In RH9.0, redhat-config-xfree86 configures hardware aspects of X.

Anytime I received an "out of range" error it's been that X is
attempting to overdrive the monitor. I've never had to touch
/etc/sysconfig/hwconf, but I have had to use r-c-x to throttle the
refresh rates back a bit.

HIH!
Steve Gonzales, RHCE
LSU Div. of Engineering Services

> From: Tom Klem <thewiz@lvcablemodem.com>
> To: redhat-list@redhat.com
> Subject: Monitor problem in RH9.0
> Date: Thu, 13 Nov 2003 09:16:14 -0800
>
> Recently, I had occasion to swap monitors between a RH7.3 and a RH9.0
> installation. When I swapped them back, the RH9.0 is giving "out of
> range" errors from the monitor, and X will not start. I tried wiping
> out the monitor settings in /etc/sysconfig/hwconf to no avail. Kudzu
> didn't launch like I expected after removing the setting, and I may be
> living in RH7.3 land here without the specific piece of info I need to
> reset the monitor and X settings on RH9.0.
>
> I gather also, that there is no XConfigurator on RH9.0 as well.
>
> Any suggestions would be appreciated.
>
> Tom Klem
>

-- 
redhat-list mailing list
unsubscribe mailto:redhat-list-request@redhat.com?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list

• Previous message: Nitin: "Re: how to use tar with scp"
• Maybe in reply to: Tom Klem: "Monitor problem in RH9.0"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]