RE: Terminal emulation problem!!!

I think that you should check the terminal settings on the ssh client you
are connecting from. You may not have the correct fonts on the local
display. Or incorrect terminal settings. I have seen this numerous times,
going between windows/solaris/linux/etc. If you could provide more details
about the problem, perhaps we could provide a more detailed solution.

Regards,

Gavin McDonald
========================
EVI Logistic Enterprises
email: me@xxxxxxxxxxxx
phone: (604) 313-3845


-----Original Message-----
From: redhat-list-bounces@xxxxxxxxxx [mailto:redhat-list-
bounces@xxxxxxxxxx] On Behalf Of Paykar Chamani
Sent: Saturday, February 25, 2006 8:29 PM
To: General Red Hat Linux discussion list
Subject: RE: Terminal emulation problem!!!

Hi,

I tried everything to get programs like "ntsysv", "elinks", etc... to
display properly over an ssh session without success. I get a lot of
weird characters even when I set LANG="en_US". Any suggestions will be
greatly appreciated.



--
redhat-list mailing list
unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list

--
redhat-list mailing list
unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list