RE: COLLISIONS



-----Original Message-----
From: winston
Sent: Monday, June 26, 2006 9:03 AM
To: 'General Red Hat Linux discussion list'
Subject: RE:COLLISIONS

Hi ,
I am getting a collision on my my eth1 which is connected
to my lan . when i do an ifconfig what could be the problem
is it the NIC or the LAN cause i do not have ip's on my network
that are conflicting. how do i troubleshoot this problem


I probably wouldn't worry about "a collision" as in one, but if you
mean many and its still incrementing, you may want to look at
one side set to full duplex w/ the other set to half, bad cable, to
long a run...

marc


--
redhat-list mailing list
unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list

Relevant Pages

  • Re: Ethernet Chip Suggestion
    ... These runts with bad CRC indicate the collision on LAN. ... short packets could not be captured. ...
    (comp.arch.embedded)
  • Collision Detection and Jam Signal on the LAN
    ... I want to get the collisions on the LAN. ... I know that in half-duplex ... network there is jam signal to demonstrate the collision occured. ...
    (comp.dcom.lans.ethernet)