Re: Gigabit ethernet

On Thu, 2006-07-27 at 09:47 +0200, Stephane Branchoux wrote:
Hello,

I use 2.6.9-34.0.2.ELsmp kernel on a Red Hat Enterprise Linux AS
release 4 box.

# lspci |grep -i ethernet
02:01.0 Ethernet controller: Intel Corporation 82546GB Gigabit Ethernet
Controller (rev 03)

Eth1 card is connected on a 2950 cisco switch (on a giga port RJ45,
speed 1000 and duplex full ).

When i use :

ethtool -s eth1 speed 1000 duplex full autoneg off, then mii-tool -v
gives me :

eth1: negotiated, link ok
product info: vendor 00:50:43, model 2 rev 5
basic mode: autonegotiation enabled
basic status: autonegotiation complete, link ok
capabilities: 100baseTx-FD 100baseTx-HD 10baseT-FD 10baseT-HD

How to activate 1000baseTx-FD ?

mii-tool is obsolete (even says so in the man page)

use

#/sbin/ethtool eth1

to get all the information you need.

--
Karl Latiss <karl.latiss@xxxxxxxxxxxxx>
Atvert Systems

--
redhat-list mailing list
unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list

Relevant Pages

  • 2.6.12.2 tg3 driver doesnt ARP on 8021q 802.1q dot1q VLAN interfaces?
    ... 0000:00:00.0 Host bridge: ServerWorks GCNB-LE Host Bridge ... Ethernet ... 0000:01:06.0 Ethernet controller: Intel Corp. 82546EB Gigabit Ethernet ...
    (Linux-Kernel)
  • upgrade 8.0 to core2 has broken P4 Xeon (S2721) gigabit ethernet
    ... which has 1 dual Gigabit ethernet and 1 single 100 Mg port. ... Before I upgraded I had my ethernet connected to one of the Gigabit ... 07:01.0 Ethernet controller: Intel Corp. 82546EB Gigabit Ethernet ...
    (Fedora)
  • EBOOT SMSC91C113L Ethernet registers not accessible
    ... Ethernet Boot Loader Configuration: ... Peter Going to detect and initialize Ethernet controller first time. ... Peter After detecting and initialize Ethernet controller first time -1. ... SMC Ethernet card detected at I/O base 0xBF500000 ...
    (microsoft.public.windowsce.platbuilder)
  • EBOOT SMSC91C113L Ethernet registers not accessible
    ... Ethernet Boot Loader Configuration: ... Peter Going to detect and initialize Ethernet controller first time. ... Peter After detecting and initialize Ethernet controller first time -1. ... SMC Ethernet card detected at I/O base 0xBF500000 ...
    (microsoft.public.windowsce.embedded)
  • EBOOT SMSC91C113L Ethernet registers not accessible
    ... Ethernet Boot Loader Configuration: ... Peter Going to detect and initialize Ethernet controller first time. ... Peter After detecting and initialize Ethernet controller first time -1. ... SMC Ethernet card detected at I/O base 0xBF500000 ...
    (microsoft.public.windowsce.app.development)