Re: [SLE] How can I make a devel rpm?
From: Joe Morris (NTM) (Joe_Morris_at_ntm.org)
Date: 08/22/03
- Previous message: Alfredo Cole: "[SLE] CableFree II access point and lan card"
- In reply to: Marshall Heartley: "Re: [SLE] How can I make a devel rpm?"
- Next in thread: Marshall Heartley: "Re: [SLE] How can I make a devel rpm?"
- Reply: Marshall Heartley: "Re: [SLE] How can I make a devel rpm?"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Date: Fri, 22 Aug 2003 21:51:06 +0800 To: suse-linux-e@suse.com
On 08/22/2003 08:56 PM, Marshall Heartley wrote:
>Ok I did kind of misunderstood! So basically all I have to do is go
>into the spec file and split them. I will give this a shot. Thanks for
>putting some clarity on the issue. The package that I am trying to make
>a rpm of (Gimp 1.3.18) I do want the devel files. I do compile plug-ins
>for Gimp.
>
Sorry if I still am not clear since I have not been following the whole
thread. Didn't you say you compiled Gimp 1.3.18 via configure, make,
then checkinstall? If that is correct, you should have the files the
"devel" package would have installed, had the package been done by
SuSE. There is nothing more to install for Gimp, only the plug-ins you
might want. The development headers, etc., the plug-ins would need from
Gimp are there already. Some files might be a pre-requisite for the
compile that would have been installed by installing a SuSE packaged
devel package, but by installing via configure, make, and checkinstall,
those files are there and you should be able to compile your plug-ins. HTH.
-- Joe Morris New Tribes Mission Email Address: Joe_Morris@ntm.org Web Address: http://www.mydestiny.net/~joe_morris Registered Linux user 231871 God said, I AM that I AM. I say, by the grace of God, I am what I am. -- Check the headers for your unsubscription address For additional commands send e-mail to suse-linux-e-help@suse.com Also check the archives at http://lists.suse.com Please read the FAQs: suse-linux-e-faq@suse.com
- Previous message: Alfredo Cole: "[SLE] CableFree II access point and lan card"
- In reply to: Marshall Heartley: "Re: [SLE] How can I make a devel rpm?"
- Next in thread: Marshall Heartley: "Re: [SLE] How can I make a devel rpm?"
- Reply: Marshall Heartley: "Re: [SLE] How can I make a devel rpm?"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
