Re: [SLE] Thinking about 3ware and Raid 1+0 performance
From: Greg Freemyer (freemyer-ml_at_NorcrossGroup.com)
Date: 08/29/03
- Previous message: Donn aka n5xwb Washburn: "Re: [SLE] cannot open ftp site"
- In reply to: Herman Knief: "Re: [SLE] Thinking about 3ware and Raid 1+0 performance"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
To: Suse <suse-linux-e@suse.com> Date: 29 Aug 2003 16:22:12 -0400
On Thu, 2003-08-28 at 23:27, Herman Knief wrote:
> Couple of questions: When you built the volumes, did you allow the
> controller enough time to complete it's build process before you began
> running tests? (Especially for the RAID 10) Have you verified the
> version of firmware on the card matches the driver release you are
> running? Are you running this in a 64bit/66MHz slot, 64bit/33MHz or
> 32bit/33MHz?
>
> I've used a number of these in all sorts of configs and always achieved
> the expected results.
>
> - Herman
Herman,
How do I know when the Raid 1+0 build process is done? If I break a
mirror and rebuild it I get a percentage completion indicator via 3dmd.
When I built the Raid 1+0 from scratch, 3dmd immediately showed the unit
operational. i.e. It was not degraded from what I could tell from the
very first bootup.
I have lost my testing oppurtunity for a week or two.
When I get the hardware back, I will try it again based on what you
said. In particular I will let the array sit overnight before I start
any performance tests.
Thanks
Greg
-- Greg Freemyer -- Check the headers for your unsubscription address For additional commands send e-mail to suse-linux-e-help@suse.com Also check the archives at http://lists.suse.com Please read the FAQs: suse-linux-e-faq@suse.com
- Previous message: Donn aka n5xwb Washburn: "Re: [SLE] cannot open ftp site"
- In reply to: Herman Knief: "Re: [SLE] Thinking about 3ware and Raid 1+0 performance"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Relevant Pages
|
