Re: [SLE] "Failed" message in startup
From: Bill Wisse (wiswp_at_niue.nu)
Date: 08/31/03
- Previous message: Terence McCarthy: "Re: [SLE] Why have swap"
- In reply to: Andreas Winkelmann: "Re: [SLE] "Failed" message in startup"
- Next in thread: Andreas Winkelmann: "Re: [SLE] "Failed" message in startup"
- Reply: Andreas Winkelmann: "Re: [SLE] "Failed" message in startup"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
To: suse-linux-e@suse.com Date: Sat, 30 Aug 2003 11:51:23 -1100
On Saturday 30 August 2003 10:53, Andreas Winkelmann wrote:
> Bill Wisse wrote:
> >>>Start up log says :
> >>>
> >>>Setting up IDE DMA mode
> >>>
> >>>/dev/hda:
> >>>
> >>> setting using_dma to 1 (on)
> >>>
> >>> using_dma = 1 (on)
> >>>
> >>>done
> >>>
> >>>Is there anything else I should do?
> >>
> >>Maybe you want to check if dma is enabled with "hdparm /dev/hda", if it
> >>is activated (1) everything is oki.
> >
> > Checked , but it says DMA = 0 (off).
>
> Which Mainboard do you have? And which kernel-version?
Intel 82801BA-ICH2
Kernel 2-4-20
--
Greetings from
/bill at 169 west , 19 south.
Disclaimer: Any errors in spelling, tact, or fact are
transmission errors."
--
Check the headers for your unsubscription address
For additional commands send e-mail to suse-linux-e-help@suse.com
Also check the archives at http://lists.suse.com
Please read the FAQs: suse-linux-e-faq@suse.com
- Previous message: Terence McCarthy: "Re: [SLE] Why have swap"
- In reply to: Andreas Winkelmann: "Re: [SLE] "Failed" message in startup"
- Next in thread: Andreas Winkelmann: "Re: [SLE] "Failed" message in startup"
- Reply: Andreas Winkelmann: "Re: [SLE] "Failed" message in startup"
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]