RE: [SLE] Newbie Linksys EG1032 1000 Mbps
From: Rob Sell (robs_at_facnd.com)
To: "'mark bannister'" <firstname.lastname@example.org>, <email@example.com> Date: Sat, 6 Sep 2003 09:34:19 -0500
We need a little more info, are you using a router or are you plugging
directly into a cable/dsl modem? You say you get an ip but cannot get
anywhere on the internet, can you go to websites via ip addresses? Try this
http://220.127.116.11/ that should take you to http://slashdot.org/
From: mark bannister [mailto:firstname.lastname@example.org]
Sent: Saturday, September 06, 2003 9:07 AM
Subject: [SLE] Newbie Linksys EG1032 1000 Mbps
VERY new to Linux and SuSE.
SuSE 8.2 i386 purchased
Trying to install EG1032 network card. Card is identified as a NS82030
(I think that's right) and that driver is loaded (is that the right term?).
There is an onboard NIC (eth0) as well that I have yet to get disabled
(jumper on the board somewhere). It works fine.
If I plug the network cable into the EG1032 it gets an IP address during
boot but I cannot connect to the internet. I have read on other groups
that the NS82030 driver works in SuSE (not sure of the build) but I'm
not having any luck.
Are there some standard settings I can try? And how would I make them
and/or where would I find the info.
-- Check the headers for your unsubscription address For additional commands send e-mail to email@example.com Also check the archives at http://lists.suse.com Please read the FAQs: firstname.lastname@example.org -- Check the headers for your unsubscription address For additional commands send e-mail to email@example.com Also check the archives at http://lists.suse.com Please read the FAQs: firstname.lastname@example.org