Re: [SLE] Yast problems

From: Alberto Santana (asantana_at_uprm.edu)
Date: 03/16/04

  • Next message: Jason Joines: "Re: [SLE] Deploying SuSE Workstations" 
    To: <suse-linux-e@suse.com>
Date: Tue, 16 Mar 2004 12:39:59 -0400

    I did SuSEconfig --verbose --module tetex and it says:

    Running in verbose mode.
    Running module tetex only
    Reading /etc/sysconfig and updating the system...
    Executing /sbin/conf.d/SuSEconfig.tetex...

    it stays there. Not too much info I would say.
    alberto
    -------------------------------------------------------------------
    Alberto Santana, Ph.D.
    Center for Chemical Sensor Development for Explosives
    Department of Chemistry
    University of Puerto Rico - Mayaguez
    P.O. Box 9019 Phone: (787) 832-4040 x2485
    Mayaguez PR, 00681-9019 http://www.uprm.edu/~asantana
    ----- Original Message -----
    From: "user86" <user86@earthlink.net>
    To: <suse-linux-e@suse.com>
    Sent: Tuesday, March 16, 2004 10:03 AM
    Subject: Re: [SLE] Yast problems

    > On Tuesday 16 March 2004 07:04, Alberto Santana wrote:
    > > At this moment Yast2 will not finish the SuSEconfig section after a
    > > sotfware installation or an online update. When it gets to
    > > SuSEconfig.tetex, it stays there forever. It is a default system with
    all
    > > the SuSE updates (last one was openssh).
    > >
    > > Any ideas???
    >
    > As root, what does the output of the following command say when it gets to
    > that SuSEconfig section?:
    >
    > SuSEconfig --verbose 

    -- 
Check the headers for your unsubscription address
For additional commands send e-mail to suse-linux-e-help@suse.com
Also check the archives at http://lists.suse.com
Please read the FAQs: suse-linux-e-faq@suse.com
  • Next message: Jason Joines: "Re: [SLE] Deploying SuSE Workstations"

    Relevant Pages