Re: [opensuse] Two NIC's, one connected, Ping Both...?

At 09:00 AM 7/14/2008, John Andersen wrote:
On Mon, Jul 14, 2008 at 1:24 AM, William Hammond <tech@xxxxxxxxxxx> wrote:
> The real problem here is that I so far have been unable to connect
> to a remote 10.3 Server.
>
> Firewall is active, but all necessary ports are open,
> Server is behind a Router, and the Router is doing Port Forwarding.
> the this case, 5901,5801,22 ---
>
> This is the only site I can;t get into with Putty. (SSH on 22)
>
> One thing that bothers me is the Server.
>
> Like most modern boards it has two built in NIC.s and 100MB and a 1GB.
> Both are configured with Private IP's xxx.xxx.xxx.200 and xxx.xxx.xxx.201
> (I bet nobody can guess what the xx's represent.. ;-) )
>
> Only one of these RJ45 Ports is connected, but I can Ping them both.


From where?\

Local XP Workstations. Everything is behind the Router

From the server itself (pinging its own nics) its normal.
From anywhere else on that private subnet its not normal unless said
server is a router that routes between its two nics.

If this is the case, I don't know how or why. I didn't set up any IP forwarding on the Server.
Each just has a private IP, same Subnet, and the Router Gateway Address.
How could I test for this....?


If you can't connect with putty, make sure both are using the same
protocol (ssh 2 preferably).


--
----------JSA---------
Sig line deleted for the humor impaired.
--
To unsubscribe, e-mail: opensuse+unsubscribe@xxxxxxxxxxxx
For additional commands, e-mail: opensuse+help@xxxxxxxxxxxx

--
To unsubscribe, e-mail: opensuse+unsubscribe@xxxxxxxxxxxx
For additional commands, e-mail: opensuse+help@xxxxxxxxxxxx

Relevant Pages

  • Re: Cannot connect to RWW from home PC
    ... That would be the address you need a DNS record for. ... You say "And in the router you need to forward to your external nic IP" ... Still can't telnet to any of your ports at your public ip address. ... Heres' the info for our server: ...
    (microsoft.public.windows.server.sbs)
  • Re: Simultaneous DSL and cable modem access on a SBS network...sorf ot.
    ... Internet Connection wizard on the SBS box, ... "More Information" button on what ports need to be opened to the SBS. ... The server and the fax (the line the DSL modem ... The cable modem already has a router attached to it as well, ...
    (microsoft.public.windows.server.sbs)
  • Re: SBS 20003 R2 Newbie
    ... Try using a smarthost to send outbound mail from your SBS server. ... you may have better luck using the Earthlink ... In the router, you need to forward some ports to your SBS NIC: ...
    (microsoft.public.windows.server.sbs)
  • Re: Set up Remote Connection
    ... To know what ports you need to forward for RWW and/or OWA, VPN, etc: ... Configuring Virtual Servers on Belkin Router: ... run my internet connection directly from the cable modem to the ... server, and then to the router through the second NIC. ...
    (microsoft.public.windows.server.sbs)
  • Re: Home Networking Question: Bridging/IP Forwarding between 2 LAN segments
    ... WAN port to the switch. ... Connect server 6 to the Westell and configure as necessary to allow ... Connect the WAN port on the Linksys router to the Westell device (or ... Linksys LAN ports. ...
    (microsoft.public.win2000.networking)