[opensuse] SMART daemon question


I have to ask, even though I know the probable answer: I am getting the
following log messages on a machine running 11.0. The disk is a IDE
disk. Could there be any software issues that cause this message to be
given when it should not? Could I have something configured wrong? Or
should I trust that a disk is becoming an ex-disk?

Device: /dev/sdc, SMART Prefailure Attribute: 1 Raw_Read_Error_Rate
changed from 50 to 49
Device: /dev/sdc, SMART Usage Attribute: 195 Hardware_ECC_Recovered
changed from 50 Device: /dev/sda, SMART Usage Attribute: 199
UDMA_CRC_Error_Count changed from 91 to 1
Device: /dev/sdb, SMART Prefailure Attribute: 1 Raw_Read_Error_Rate
changed from 59 to 56
Device: /dev/sdb, SMART Usage Attribute: 194 Temperature_Celsius changed
from 43 to 42
Device: /dev/sdb, SMART Usage Attribute: 195 Hardware_ECC_Recovered
changed from 59 to 56
Device: /dev/sdc, SMART Prefailure Attribute: 1 Raw_Read_Error_Rate
changed from 49 to 48
Device: /dev/sdc, SMART Usage Attribute: 195 Hardware_ECC_Recovered
changed from 49 to 48

I'm not totally familiar with the SMART tools more than these types of
messages. Is there a command that could provide more information on what
is going on?

Thanks for any help.

--
Roger Oberholtzer

OPQ Systems / Ramböll RST

Ramböll Sverige AB
Kapellgränd 7
P.O. Box 4205
SE-102 65 Stockholm, Sweden

Office: Int +46 8-615 60 20
Mobile: Int +46 70-815 1696

And remember:

It is RSofT and there is always something under construction.
It is like talking about large city with all constructions finished.
Not impossible, but very unlikely.


--
To unsubscribe, e-mail: opensuse+unsubscribe@xxxxxxxxxxxx
For additional commands, e-mail: opensuse+help@xxxxxxxxxxxx

Relevant Pages

  • Re: New HDD Installation
    ... "John John" wrote: ... a single partition disk. ... confirm or change the active flag of the partition using the FDISK command. ... There are other ways to mark the partition active, either with a Windows ...
    (microsoft.public.windowsxp.general)
  • Re: Forgot to put old_rootvg to sleep before reboot - How to Wake
    ... Performs operations on existing alternate rootvg volume groups. ... To rename Alternate Disk Volume Group: ... The alt_rootvg_op command can be used to determine which disk is the ... flag) can be executed at this time. ...
    (comp.unix.aix)
  • PC8477 Demo Program
    ... The PC8477 Demo Program is designed to allow access to all software commands and registers of National Semiconductor's PC8477 Advanced Floppy Disk Controller. ... The left center indicates the number of bytes transferred during the last command issued. ...
    (comp.sys.ibm.ps2.hardware)
  • Re: Windows XP boot failure
    ... If you have a friend with a real Windows ... read/write to the drives using a command line ... For more information on a specific command, ... CHKDSK Checks a disk and displays a status report. ...
    (microsoft.public.windowsxp.basics)
  • Re: New HDD Installation
    ... DISKPART> list disk ... DISKPART> select partition 1 ... You can do the same thing starting with the "list volume" instead of the "list disk" command, then selecting volumes to gain focus. ... At this point I haste to point out that this is mostly for educational purposes and for you to gain an inner working knowledge of disks and partitions and how Windows works with them. ...
    (microsoft.public.windowsxp.general)