Re: [opensuse] Anyone have a working vnc server start script they can share?
- From: James Pifer <jep@xxxxxxxxxxxxxxxx>
- Date: Tue, 23 Jun 2009 12:07:07 -0400
On Tue, 2009-06-23 at 10:42 -0400, Chuck Payne wrote:
On Tue, Jun 23, 2009 at 10:10 AM, Per Jessen<per@xxxxxxxxxxxx> wrote:
James Pifer wrote:
Anyone have a working vnc server start script they can share? Right
now I start a vnc server manually like this:
vncserver :49 -alwaysshared -geometry 1024x768
Copy /etc/init.d/skeleton to e.g. /etc/init.d/startvnc, then modify
according to our specs above. Start at level 3 and 5, require at least
network before starting.
I would like to have this start automatically with these settings.
After you've created the script, run 'insserv startvnc'.
/Per
--
Per Jessen, Zürich (12.6°C)
--
To unsubscribe, e-mail: opensuse+unsubscribe@xxxxxxxxxxxx
For additional commands, e-mail: opensuse+help@xxxxxxxxxxxx
You can also put into boot.local, this is called at the very enf of boot up.
I don't think boot.local is called at the end, but more toward the
beginning of the boot up. I think after.local is called near the end.
Either way, I tried both and had some success with after.local, but
didn't work 100%. You also have to setup environment variables.
I've also tried the rclocal workaround that's out there and have limited
success with that. I miss Redhat's rc.local.
I'm going to attempt the init script as Per suggested.
Thanks,
James
--
To unsubscribe, e-mail: opensuse+unsubscribe@xxxxxxxxxxxx
For additional commands, e-mail: opensuse+help@xxxxxxxxxxxx
- References:
- Prev by Date: Re: [opensuse] Re: Hardware problem
- Next by Date: Re: [opensuse] Re: Hardware problem
- Previous by thread: Re: [opensuse] Anyone have a working vnc server start script they can share?
- Next by thread: [opensuse] Epson R2880 Photo under Linux
- Index(es):
Relevant Pages
|
