Redhat 9 and wireless PCMCIA lan

• Previous message: scott: "XFS and badblocks - how to scan / repair?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

Date: Sun, 29 Feb 2004 00:54:19 +0100

Hi there

I have successfully installed RH9 alongside windows XP on my laptop. My
PCMCIA controller is also installed. I tried following the guide on
http://www.canit.se/~oli/wl/ to install my D-link DWL610 but the problem is that when I try to watch
the kernel log with: tail -f /var/log/kern.log the file does not exist.
Furthermore if I run
insmod pcmcia_core.o
insmod yenta_socket.o
insmod ds.o
They are all loaded already meaning that even if I could read the kern.log
file I would not see an entry where I could see the vendor and device IDs
of my wireless lan card.

I have tried finding it with lspci -vv which only gives this:
00:08.0 CardBus bridge: O2 Micro, Inc. OZ6912 Cardbus Controller
        Subsystem: Uniwill Computer Corp: Unknown device 3000
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping+ SERR- FastB2B-
        Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- <TAbort- <MAbort- >SERR- <PERR-
        Latency: 168
        Interrupt: pin A routed to IRQ 9
        Region 0: Memory at 10000000 (32-bit, non-prefetchable) [size=4K]
        Bus: primary=00, secondary=02, subordinate=05, sec-latency=176
        Memory window 0: 10400000-107ff000 (prefetchable)
        Memory window 1: 10800000-10bff000
        I/O window 0: 00004000-000040ff
        I/O window 1: 00004400-000044ff
        BridgeCtl: Parity- SERR- ISA- VGA- MAbort- >Reset- 16bInt- PostWrite+
        16-bit legacy interface ports at 0001

But nothing with my wireless lan card.

Does anyone have any suggestions on how to continue?

Thx in advance

David

• Previous message: scott: "XFS and badblocks - how to scan / repair?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]