Re: epson scanner?
Date: Thu, 05 Aug 2004 12:56:10 -0500
On Thu, 05 Aug 2004 11:48:12 -0400, James wrote:
> #Epson Perfection 1670
> usb 0x04b8 0x011f
> /dev/usb/scanner0 bus=usb
> firmware /usr/local/etc (note this points to firmware "ESFW30.bin")
Does the firmware path include the filename?
also in my snapscan.conf the /dev/usb/scanner0 line is commented out.
sane-find-scanner located my scanner at libusb:001:003
I then had to do a chmod a+rw /proc/bus/usb/001/003
this is reset upon reboot.
To make the above execute every time on every boot I had to add the
command to /etc/rc.d/rc.local
I then run gimp and do an aquire>device dialog to use my scanner(it has a
35 sec warmup the 1st time).
Hope this helps.
- default home page
... I set my browser home deafult to ... Look under C:\Program Files for these folders. ... >4) Reboot your machine. ... >can reset your homepage or access the net. ...
- Re: Cannot set Background Intelligent Transfer Service to "manual"!
... I have been trying to reset the service using the Services App. ... I tried again in safe mode, but no luck. ... STILL reset back to automatic after a reboot! ... RegMon (highlighting changes ...
- Re: Do I have a virus? XP login issue
... > contained a virus. ... > * Any attempts to reboot after this were met with the same issue. ... > * At this point, I could not execute System Restore, so I got out my ... > XP disk and did a Windows repair. ...
- Re: Time errors
... Why would you reboot your PC if it was already running the ... The last several timeS I pointed to one 'buntu installation as the source of the problem i.e. it resets the BIOS clock to local time a la windows ... In ubuntu there is NO CONFLICT, it decides to use local time only and sets the bios clock to it. ... I have however demonstrated that since the system at fault resets the BIOS clock only after running this much is proof that it does not need it to be reset while it is runing. ...
- Re: Cannot reset Background Intelligent Transfer Service to "manual"!
... I have been trying to reset the service using the Services App. ... I tried again in safe mode, ... STILL reset back to automatic after a reboot! ... restart in safe ...