Re: FC6 cannot see my /hdb1 anymore

circuit_breaker@xxxxxxxxxx schreef:
Hi,

I made a fresh install of FC6 and one of the partitions cannot be
mounted. I'm getting this message:
"/dev/hdb1 already mounted or /hdb1 busy"

When I type: "umount /dev/hdb1" I got: "/dev/hdb1" not mounted.

The drive shows up with a "dmesg" command ("hdb:hdb1"). Also, when I
put the hard disk in a FC4 based system, it recognizes it properly as
an ext2 filesystem, just like it was before the upgrade...

Any suggestions are wecomed.

Thanks.

Disk busy being searched by Beagle?
.

Relevant Pages

  • Re: New computer
    ... > thing I would do is to run Partition Magic, and create partitions like I ... Ghost your current HD for later restore to your current machine. ... Remove the hard disk and install it in your new computer. ... Folow the on-screen instructions and install new drivers as necessary. ...
    (microsoft.public.win2000.general)
  • Re: Pagefile.sys
    ... that everyone would think the first partition on the first hard disk would ... the first partition of the second hard disk would be D: and then the ... then when the first hard disk drive partitions were fully assigned the ...
    (microsoft.public.windowsxp.configuration_manage)
  • Re: renovate partitions without reinstalling
    ... > Supousing that you will delete your windows partitions, ... Hold it...am I starting up from the rescue disk or from the hard disk? ... > Device Boot Start End Blocks Id System ...
    (Fedora)
  • RE: Windows XP Home to a new wiped clean harddrive (HELP)
    ... Recreating the partitions through Disk Management while plugin your Hard disk ... that windows is missing a registry key. ...
    (microsoft.public.windowsxp.setup_deployment)
  • Re: Ni Partitions
    ... You may need a Boot Manager? ... You may end up losing partitions on your first ... I recently added another 40GB hard disk & created 4 partitions. ... in the new hard disk so that I can install WinXP Pro in one of the 4 ...
    (microsoft.public.windowsxp.general)