is it possible not to load networking at boot (Makes using system near impossible)

From: Robbie Williams (r.williams246_at_verizon.net)
Date: 03/12/04

Next message: Charles Prince: "Re: Pls Help System freeze"
Previous message: graham marsden: "Re: nVidia problems after X update"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

Date: Fri, 12 Mar 2004 09:00:11 GMT

There is some faulty scripting going on with yast or just SUSE 9.0
(AMD64) and my NIC because no matter if I detect and save my settings in
Yast for my nic or i write eth0 file in /sysconfig/network it goes by by
after each reboot and the system hangs on reboot. I had a trick by
which I used the boot install disk to install the driver then boot the
system but since I updated almost everything including the kernel this
doesn't work anymore. Please help.

Robbie

Next message: Charles Prince: "Re: Pls Help System freeze"
Previous message: graham marsden: "Re: nVidia problems after X update"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

Relevant Pages

Re: [SLE] Am I in DMA HD mode or not?
... > Using yest you tell the system to switch to hda mode on the next reboot. ... > if that hardhangs your machine (because your IDE controller is not properly ... I tried Yast as well and the machine locked. ...
(SuSE)
Re: [opensuse] partly solved - its the Powerline networking - WAS: local network/ADSL router
... Have you tried to setup static address for your connection? ... You need some local address that is not used by router as DHCP range. ... Had to first go through a full cycle with YaST: ... But never on reboot (of course I use ON CABLE CONNECT in YasT for manual start of connection and ON BOOT for preparing a rebooting. ...
(SuSE)
Re: [opensuse] Re: [Powerline networking - WAS: local network/ADSL router not available after bo
... Have you tried to setup static address for your connection? ... You need some local address that is not used by router as DHCP range. ... Had to first go through a full cycle with YaST: ... But never on reboot (of course I use ON CABLE CONNECT in YasT for manual start of connection and ON BOOT for preparing a rebooting. ...
(SuSE)
Fixed: Re: [opensuse] Wireless disappeared?
... to do now, is try to make sure it stays there on reboot, but frankly, if I ... And, as mentioned, when module is loaded than run YaST Network or command: ...
(SuSE)
Re: [opensuse] Re: [Fwd: Re: local network/ADSL router not available after boot - manual reconf
... Have you tried to setup static address for your connection? ... In YaST -- Network Devices -- Network Card use for this time Traditional Method with ifup. ... Had to first go through a full cycle with YaST: deleting card configuration ... ... But never on reboot (of course I use ON CABLE CONNECT in YasT for manual start of connection and ON BOOT for preparing a rebooting. ...
(SuSE)